Why we need digital systems, Electrical Engineering

Assignment Help:

Q. Why we need digital systems?

EASIER TO PROCESS: For the reason that digitized information breaks all information into discrete units the information is easier to process and manipulate. This processing power is what has built the basis for the incredible advances that have taken place in audio and digital processing.

EASIER TO STORE: Digital information is easier to store because of the simplicity of it's form.

• Less Affected by Noise

• More Relaible

• Has lower cost than Analog Systems

312_Why we need digital systems.png


Related Discussions:- Why we need digital systems

Determine the transformer winding currents, Q. Three single-phase 100-kVA, ...

Q. Three single-phase 100-kVA, 2400:240-V, 60-Hz transformers (each ofwhich has an equivalent series impedance of 0.045+j0.16 referred to its low-voltage side) are connected to fo

Explain atomic structure and energy band diagram of silicon, Explain Atomic...

Explain Atomic structure and Energy Band Diagram of Silicon. Silicon : It is other most commonly used semiconductor. Atomic number of it is 14. The no. of electrons in first,

Explain the steps of the evolution of the microcontroller, Question: a)...

Question: a) Give one reason why a "subroutine" could be written into the body of the main program. b) With the help of the diagram below, write down the sequence of the ni

Metering standards, Metering Standards Relevant standards on metering ...

Metering Standards Relevant standards on metering are given in Table. Table: Relevant Metering Standards  Standards Description

Briefly explain about transients in circuits, Q. Briefly explain about Tran...

Q. Briefly explain about Transients in circuits? The total response of a system to an excitation that is suddenly applied or changed consists of the sum of the steady-state and

Electric machines, a shunt motor supplied at 230V rms runs at 900rev/min wh...

a shunt motor supplied at 230V rms runs at 900rev/min when the armature current is 30A.the resistance of the armature circuit is 0.4 ohms.find the armature input

LED should also show the rounded percentage , The LEDs should also show th...

The LEDs should also show the rounded percentage of the full scale output. Since there are 8 LEDs every one represents 12.5%. Though, since we want the rounded percentage the LED o

Characteristics of unijunction transistor, Characteristics of  unijunction...

Characteristics of  unijunction transistor: Characteristics : The static emitter characteristic of UJT at a given inter base voltage VBB in shown in fig. From fig., it is no

Find the state of operation and operating point, Considering the circuit sh...

Considering the circuit shown in Figure (a), find the state of operation and operating point if the BJT has β = 80 and other typical values of a silicon BJT at room temperature.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd