Off line ups system - power supplies , Electrical Engineering

Assignment Help:

Off line UPS System

Again the two  switches  are used in this  type of ups  as online  ups. The difference  is that  here  the main  static  switch  remains normally  ON and UPS  static  switch  remains  normally OFF.

Here the load  is directly connected to the  main supply  through  main static  switch. Under the condition of power  failure, main static switch   operates to disconnect the  mains from  the load and then ups  static  switch  becomes ON to  connect the load  batter by bank through  circuit. Battery bank  suppliers  the power  to the load.


Related Discussions:- Off line ups system - power supplies

Logistical management - gis applications, Logistical management - Gis appli...

Logistical management - Gis applications: Using GIS also allows a radical improvement in daily work management practices - such as planning new installations, scheduling opera

Speech Timer, Speech timer where max time is 5 minutes Use the switche...

Speech timer where max time is 5 minutes Use the switches for: start switch reset switch use the lights to represent: the “green” light meaning the

Explain data addressing modes available in microprocessors, Explain data ad...

Explain data addressing modes available in microprocessors? Data addressing modes available in microprocessors are given below: Direct Mode Indirect Mode Register Dire

Assignment question , An audio amplifier with feedback needs gain of approx...

An audio amplifier with feedback needs gain of approximately 500 in a 3-dB bandwidth extending from 60 Hz to 25 kHz. Assume this is accomplished using a feedback network with ß=0.0

Linear and IC applications, bias compensation techniques for ac and dc char...

bias compensation techniques for ac and dc characteristics

Three byte instruction , Three byte instruction The  instruction which...

Three byte instruction The  instruction which  have 16  bit data address  as its  operand  are three byte  instruction. They  need three  memory  locations to store  them in m

Draw the logic diagram of the enabled d latch, Q. (a) Draw the logic diagra...

Q. (a) Draw the logic diagram of the enabled D latch using only NAND gates. (b) Complete the timing diagram of Figure (a) of theDlatchwhose block diagram and truth table are giv

Insulation resistance, how can we increase insulation resistance of sheet

how can we increase insulation resistance of sheet

Calculate the current flow using thevenin''s theorem, Calculate the curren...

Calculate the current flow in 30Ω resistor for the circuit in figure using Thevenin's Theorem.

Designing of a 2 way cross-over circuit for loudspeaker, Loudspeakers using...

Loudspeakers using single driver are unable to cover the entire frequency band from low frequency to high frequency. Sometimes multiband frequency is required for the bass enhancem

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd