Show that 1 millimeter of the 0.02 n h2so4 solution

Assignment Help Civil Engineering
Reference no: EM13534551

1.A load of 14 tonnes is suspended at the end of a steel rope.If the load is subjected to a maximum acceleration/deceleration of2.5m/s2, when raised and lowered, calculate the diameter of therope needed to support the load. Assume the following:

Factor of safety (FOS) : 6

Ultimate Tensile stress (UTS) = 600 MN/m2

E = 200 GN/m2

calculate the tension in the rope(F=ma)?

2.Show that 1 millimeter of the 0.02 N H2SO4solution is equivalent to 1.0 milligram CaCO3.

Reference no: EM13534551

Questions Cloud

What is the length of the core in inches if the diameter is : If the porosity of a core sample is 26 percent, the pore volume is7.7 cc, what is the length of the core in inchesif the diameter is 1.5 inches?
What is the conversion rate for parts per million by volume : What is the conversion rate for parts per million by volume (ppmv)conversion. How is this converted into atm, Pa, and torr?
Calculate specific surface : Immediately after the bouncing golf ball leaves the floor itscomponent of velocity are Vx= 0.662 m/s and Vy= 3.66 m/s. determinethe horizontal distance from the point where the bal
Is the fluid accelerating uphill : A fluid with a specific weight of 100lb/ft^3 and a negligibleviscous effects flows in a pipe. The pipe is inclined at 30degrees. Point (1) is located above point (2) in the pipe.
Show that 1 millimeter of the 0.02 n h2so4 solution : A load of 14 tonnes is suspended at the end of a steel rope.If the load is subjected to a maximum acceleration/deceleration of2.5m/s2, when raised and lowered, calculate the diameter of therope needed to support the load. Assume the following:
Compute the pressure at a point in a building : A rectangular culvert 4 feet x 6 feet is running full and discharging 3,500 cfm. There is no friction loss. Find the velocity in fps. The culvert empties into a 10 ft wide culvert and the velocity reduces to 0.6 fps. How deep is the water level in th..
What is the meaning of most efficient crosssection : A rectangular channel has a bottomwidth = b and flow depth = y. Prove that for a given area, the mostefficient rectangular cross section is one with y = b/2.
What is the concentration in ppm at the downstream reach : Five million gallons per day (mgd) of a conservative substance,with concentration of 10 mg/L is released into a stream having anupstream flow of 10.0 mgd and a substance concentration of 3 mg/L.Assume complete mixing.
What is the true air speed : Given that an aircraft flying at FL350 encounters a tailwindof 35 knots and the instrument in the cockpit shows anindicated airspeed of 310 knots. What is the standard atmosphere atthis altitude?

Reviews

Write a Review

Civil Engineering Questions & Answers

  What are the critical properties that allow for the function

Consider the components that are required for an automobile. List 5 components and identify the class of material that is used for each component. What are the critical properties that allow for the function of the material in that application

  Does the spring force increase or decrease and by how much

If the temperature of the flashlight increases to 120oF, does the spring force increase or decrease and by how much. Take the casing wall to have an outer diameter of 1.5 in., thickness 0.125in.,length L = 3 in., and elastic modulus of 300ksi.

  Calculate the final temperature of the gas for the process

The diaphragm is ruptured and fluid fills the entire volume of the vessel. Assume that the fluid is an ideal gas. After you have determined Qsub12, Wsub12, and delta U for the process, calculate the final temperature of the gas.

  Determine the density in si unit of brass

The specific weight (wt./Vol.) of brass is 520 lb/ft^3. Determine its density (mass/vol.) in SI units. Use an appropriate prefix.

  Find water depth just upstream of high broad-crested weir

Find the water depth just upstream of a 1.5 ft high broad-crested weir in a channel 6ft wide when the flow is 18 cfs

  Calculate max velocity and subsequent max altitude

A single-stage rocket is launched vertically from rest, and its thrust is programmed to give the rocket a constant upward acceleration of 6 m/s^2 . If the fuel is exhausted 20 s after launch, calculate the maximum velocity and the subsequent maxim..

  Cantilever mass-less beam

Consider a cantilever mass-less beam subjected to a concentrated mass at the tip of the beam. Assume, length L, flexural stiffness EI, and mass m.

  Find the initial velocity of the bullet before hit the tree

A 9 gram bullet is fired horizontally at a tree and is brought to a halt right before it exits the tree. the tree is 90cm thick and exerts a resistive force of 16000N on the bullet as it travels through the tree

  Alternative water resource projects

Consider two alternative water resource projects, A and B. Project A will cost $2,533,000 and will return $1,000,000 at the end of 5 years and $4,000,000 at the end of 10 years.

  Estimate the constant rate of withdrawal from reservoir

Estimate the constant rate of withdrawal (in m^3/s) from a 1375 ha reservoir in a month of 30 days during which the reservoir level dropped by 0.75 m in spite of an average inflow into the reservoir of 0.5 Mm^3/day.

  Determine how long do one have to escape

You are in an old spy movie, and have been locked into a small room (volume 1000 ft). You suddenly realize that a poison gas has just started entering the room through a ventilation duct.

  How far will a depleted uranium 30 mm round penetrate

How many centimeters of armor plating will a 150 gram 30 mm round penetrate. How far will a depleted uranium 30 mm round penetrate if its mass is 600 grams.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd