Illumination, Electrical Engineering

Assignment Help:
Ask question #Minimum 100A light assembly shop, 15 m long, 9 m wide and 3 m up to trusses is to illuminated to
a level of 200 lux. The utilization and maintenance factors are respectively 0.9 and 0.8.
Make a scale drawing of the plan of the shop and set out the required lighting points,
assuming the use of tungsten lamps and dispersive metallic reflectors

Related Discussions:- Illumination

Residential wiring and safety considerations, Q. Residential wiring and saf...

Q. Residential wiring and safety considerations? Residential electric power service commonly consists of a three-wire ac system supplied by the local power company. A distribut

Derating factor, Conductors with a temperature rating of 75 degrees C are r...

Conductors with a temperature rating of 75 degrees C are run in an area with an ambient temperature of 55 degrees C. What would be the de-rating factor that should be applied?

Load stack pointer - stack operations , Load Stack Pointer This  inst...

Load Stack Pointer This  instruction loads the stack  pointer  register with the 16 - bit  data specified in the   instruction. The 16 - bit  data. When  stored in sp  registe

General purpose diodes - types of power diodes , General Purpose Diodes ...

General Purpose Diodes The  general purpose  diodes  have relatively high reverse recovery time. The  diodes are general  made  by diffusion. They  are used  in low  speed  app

By the nodal analysis find the current delivered, By means of nodal analysi...

By means of nodal analysis, find the current delivered by the 10-V source and the voltage across the 10- resistance in the circuit shown in figure.

Explain the types of power plants, Explain in detail the various energy res...

Explain in detail the various energy resources and their availability. Explain the following: (a) Types of power plants (b) Selection of power Plants

Describe what you understand by offset voltage, a. Describe what you unders...

a. Describe what you understand by 'offset voltage' and 'offset current' of op-amp.  Discuss with a neat circuit diagram the method used for minimizing offset voltage and offset cu

Hall effect is associated with which material, Hall Effect is associated wi...

Hall Effect is associated with (A) Conductors. (B) Semiconductors. (C) Thermistors. (D)Solders. Ans: Hall Effect is associated with semiconductors.

FET, shockely equation?

shockely equation?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd