Process of steam generation unit, Mechanical Engineering

Assignment Help:

Q. Process of Steam generation unit?

BFW from water treatment area is sent to the BFW Booster pumps at temperature around 105°C. The BFW is then heated and fed to the HP BFW Pumps.

Chelant and oxygen scavenger are added to inhibit scale formation and remove DO in the BFW, respectively.

The high pressure BFW is boiled in the Steam Generators to generate 80% to 100% quality steam. Wet HP steam (for steam quality less than 100%) is sent to the HP Steam Separator to remove liquid and 100% quality steam is fed to the HP steam pipelines for injection at the well pads.

Liquid blowdown from HP Steam Separator is throttled down to lower pressure and sent to the MP Steam Separator for vapour-liquid separation.

Neutralizing amine is injected into the steam condensation system to prevent corrosion. The blowdown is cooled down and fed to the Evaporator Feed Tank.


Related Discussions:- Process of steam generation unit

Larson-miller parameter, Larson-Miller parameter: For material of exam...

Larson-Miller parameter: For material of example of calculate life in hours at temperature of 900oC, and at σ = 20 MPa. Solution Larson-Miller parameter is given by

Metallurgy, Write a literature review on the manufacture and application of...

Write a literature review on the manufacture and application of metallurgical cokes in Nigeria.

Resultant of concurrent force system, Resultant of Concurrent Force System:...

Resultant of Concurrent Force System: The resolution of forces helps in finding out the resultant of a number of forces working on a body as it decrease vectorial addition to

Brazing vs welding, Brazing Vs Welding Following are the differences be...

Brazing Vs Welding Following are the differences between brazing and welding. (i)  In brazing, the joint surfaces are not raised to fusion point (or melted) and the joint is

Desing, what is the maximum principle stress

what is the maximum principle stress

Explain the hydrostatic sensor paver machine, Explain the Hydrostatic senso...

Explain the Hydrostatic sensor paver machine Machine Name: - Hydrostatic sensor paver machine   We give Mechanical Paver and Mechanical Screed, which are used for laying w

Calculate the power of the engine, A Torsion dynamometer is used in a prope...

A Torsion dynamometer is used in a propeller shaft of a marine Engine. It is found that the shaft twists 2 o in a length of 20 meters at 120 r.p.m. If the shaft is hollow with 300

Evaluate elongation of wire, Evaluate Elongation of wire: An aerial c...

Evaluate Elongation of wire: An aerial copper wire ( E =1 x 10 5 N/m m 2 ) 40 m long is having cross sectional area of 80 mm 2 and weighs 0.6 N per meter run. I

Flux feeding & recovery system, FLUX FEEDING & RECOVERY SYSTEM The flux i...

FLUX FEEDING & RECOVERY SYSTEM The flux is fed by gravity from the flux delivery hopper mounted on the welding head through a tube into the welding zone. Flux feeding is normally

Gear boxes , Gear Boxes : Motorcycle engines do not produce their full pow...

Gear Boxes : Motorcycle engines do not produce their full power at all RPM. There is very little power at idle and the power goes up as the engine RPM increases. At a certain RPM,

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd