Determine the work related area of cad, Mechanical Engineering

Assignment Help:

Work related area of CAD

Work related to the following areas has been addressed in this interface.

Investigation of CAD data structures and the presentation of 2-D and 3-D models by using newmodeling techniques.
Specifying neutral file formats and providing access mechanisms.
Development of pre- and post-processors for interfacing various CAD systems.
Development of interface test methods, and aids for performing and documenting tests.

Related Discussions:- Determine the work related area of cad

Hot And Cold Working, What Are Difference Between Hot And Cold Working

What Are Difference Between Hot And Cold Working

Steam turbines, The steam that leaves the super-heater is expanded from 130...

The steam that leaves the super-heater is expanded from 130bar at 535°C to 25.2bar at 310°C in a high pressure turbine. The steam from the exit of the HP turbine is reheated to 535

Evaluate power transmitted by belt, Evaluate power transmitted by belt. ...

Evaluate power transmitted by belt. Sol: Let T 1 = Tension in tight side of the belt T 2 = Tension in slack side of the belt V = Velocity of belt in m/sec. = Π

Test analysis, Test Analysis: First new sand blasting mach...

Test Analysis: First new sand blasting machine prototype had arrived Asia. Installation of the machine had been carry out by external vendor. We test run the machi

Mounting systems for the welding head-carriage mounted type, Mounting Syst...

Mounting Systems For The Welding Head-Carriage mounted type In this set up, the welding head is mounted on a movable carriage. The carriage is mounted on rails and powered by a

Show the periodic functions, (a) Show following complex numbers in Rectangu...

(a) Show following complex numbers in Rectangular forms : (i) 5e 0.927j (ii) 10e 4.068j (b) Show the periodic functions by Fourier series (Harmonic series).

Evaluate the heat input per day, The input-output curve of a 60 MW power st...

The input-output curve of a 60 MW power station is provided by : I = 10 6 [8 + 8L + 0.4L 2 ] Kcl/hour where I is the input in the Kcal/hour and L is the load in MW. (a) Ev

Stations in washing system, Washing: Station 1 Loadin...

Washing: Station 1 Loading bay START Station 2 Hot Chemical wash Station 3 Running Cold bath Station 4 Hot C

Calculate composition and microstructure, It is desired to produce an iron-...

It is desired to produce an iron-carbon alloy that has a minimum hardness of 200 HB and a minimum ductility of 35%RA. Is such an alloy possible? If so, what will be its composition

Question.., Two concentric perforared plates are seperated by a 200mm laund...

Two concentric perforared plates are seperated by a 200mm launder and form the flow exit for a clarifier (figure 1). The inlet water flow of 1200 mcubed/hour into the clarifier is

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages