Mounting systems for the welding head-carriage mounted type, Mechanical Engineering

Assignment Help:

Mounting Systems For The  Welding Head-Carriage mounted type


In this set up, the welding head is mounted on a movable carriage. The carriage is mounted on rails and powered by a variable speed electric motor. The main controls such as carriage speed,current, voltage, etc., are provided on the carriage itself for facilitating ease of operation. Carriage mounted welding heads are most suitable for butt and fillet welding of plates. Depending on weld length, the rail length shall be extended to complete the welding.


Related Discussions:- Mounting systems for the welding head-carriage mounted type

State of motion of body change with force, State of motion of body change w...

State of motion of body change with force: A body on contact with the surface is being pulled along it with the increasing force from zero. How does the state of motion of bo

Application of cold service insulation, Q. Application of cold service insu...

Q. Application of cold service insulation? Cold insulation shall be installed specifically in accordance with the Manufacturer's recommendations, and generally as outlined belo

Illustrate boot-strap air evaporative cooling system, Why is it required of...

Why is it required of cooling the aeroplane ? Illustrate Boot-Strap Air Evaporative cooling system with neat sketch and T-S diagram.

Sign convention - solving problems of beam, Sign convention which is used f...

Sign convention which is used for solving problems of beam: Although different sign conventions can be used, most of the engineers use following sign conventions for shear for

Objectives of basic troubleshooting of motorcycle , Objectives After s...

Objectives After studying basics troubleshoot of motorcycle, you should be able to check, perform inspection and identify the reason(s) of various problems reported by

Explain constant velocity joint attaching to spindle, Method:- Using the co...

Method:- Using the constant velocity joint attaching to spindle. U-joint is a joint used to attach two non parallel non intersecting shafts, and it can transfer power at angle

Replace the two parallel forces by single force, Replace the two parallel f...

Replace the two parallel forces by single force: Replace the two parallel forces acting on the control lever by a single equivalent force R.   Sol.: Since single equ

Multimeter-electrical instruments , Multimeter: This is used to measure vo...

Multimeter: This is used to measure voltage, current and resistance of an electrical circuit (Figure). Figure: Multimeter

What is the basic working of cooling tower, Q. What is the basic working of...

Q. What is the basic working of Cooling Tower? Cooling towers are generally located downwind from process units to adequately disperse vapors (from exchanger leaks) and minimiz

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd