What volume of naocl will be needed

Assignment Help Civil Engineering
Reference no: EM13563746

An electric power plant consumes 2.5 million gallons per day of cooling water. To control bacterial growth (slime), 2.0 mg/L of chlorine (measured as Cl2) is injected into the make-up water fed to the system. If the specific gravity of liquid chlorine is 3.21, what volume of liquid chlorine must be stored in order to maintain a 30-day supply?

If the plant uses sodium hypochlorite instead, what volume of NaOCl will be needed? Assume that the dry density of NaOCl is 1.2 kg/L and that 1 mg/L of dissolved NaOCl is equivalent to 1 mg/L of dissolved Cl2.

Note: 1 gal = 3.78 LYou have a contaminated air stream containing 1000 ppmV of toluene and you decided to incinerate to a DRE of 99.9%. You are using butane as fuel to reach the temperature and consider the lean toluene has no heating value. Determine how much butane would you need to burn 1000 cft of contaminated air steam. Consider no heat loss in the incinarator. (b) Show that presence of toluene does not improve fuel efficiency for any practical purpose.  

Reference no: EM13563746

Questions Cloud

How long will it take to concentrate the solution : 150,000 mol of aqueous phosphoric acid (H3PO4) solution contains 5.00% H3PO4 by moles. The solution is concentrated by adding pure H3PO4 at a rate of 20.0 L/min.
Calculate the pressure and mole fractions in the vapor : Water is used in a heat exchange to cool 5 kg/s of air from 400 C to 200 C. Calculate (a) the minimum mass flux (kg/s) of the water and (b) the quantity of heat transferred (MJ) to the water each second. The water enters at 20 C and leave at 30 C.
Balance the latitudes and departures by using the compass : A four-sided closed field traverse has the following angles. A = 81 degrees 22%u201930%u201D, B = 72 degrees 32%u201930%u201D, C = 89 degrees 39%u201930%u201D, D =116 degrees 23%u201930%u201D.
Determine the maximum velocity that the skier will achieve : A person with a mass of 200kg wearing snow skis is gliding down a long slope at an angle of 20 degrees. Each ski is 200cm long and 5 cm wide. The pressure of the skis on the snow melts a thin layer of water so that a .1mm layer of water exists under ..
What volume of naocl will be needed : If the plant uses sodium hypochlorite instead, what volume of NaOCl will be needed? Assume that the dry density of NaOCl is 1.2 kg/L and that 1 mg/L of dissolved NaOCl is equivalent to 1 mg/L of dissolved Cl2.
Derive an equation that would allow for direct calculation : A closed system of 0.123kg undergoes a frictionless, quasi-static process along the path PV=C from 100kpa to a final state where the volume is twice the initial volume. During the process 8140 N-m of work is done by the system. What is the final spec..
How long would you figure the soil will take to reach : An oil storage area, abandoned 10 years ago, had spilled oil on the ground and saturated the soil at a concentration of perhaps 400 mg/kg of soil. A fast food chain wants to build a restaurant there, and samples the soil for contaminants.
What is the minimum chain length for the application : A motorcycle sprocket on the rear wheel has a diameter of 24 cm, and trhe driver sprocket has a diameter of 4.0 cm. The driver sprocket shaft and rear axle are 60 cm apart. What is the minimum chain length for the application.
Determine the number of truck loads required to obtain : For construction of an embankment, the soil is transported from a borrowed area using a truck which carries 5.5 m^3 of soil at a time, with the following details: For the Borrowed Pit: bulk unit weight= 16 KN/m^3

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find what is the annual crash rate for the intersection

The four approach volumes per day at this intersection are 28,648, 23,856, 12,150, and 10,174. The crash totals for the last 3 years are 91, 96, and 87. What is the annual crash rate for this intersection

  Determine what is the coefficient of static friction

A block begins to slide down a ramp after being elevated to an angle of 47.5 degrees. What is the coefficient of static friction

  Determine what does the equation reduce to in steady flow

Define what each term in the equation means. Overall, what quantity is being conserved? Under what conditions might you be justified in assuming that non-linear terms are not important

  Compute the value of the objective function and decision

Solve the following LP using the graphical method (graph sheets attached). Compute the value of the objective function and decision variables at optimality, and indicate which statement best describes the solution.

  Draw all aldehyde and ketone isomers of c6h12o

What is the reaction that occurs with hexanal and propanol (give both the hemiacetal and acetal products)?

  Determine maximum shearig stress in the shaft

A hollow steel shaft with an outside diameter of 400 mm and inside diameter of 300mm is subjected to the torque of 300 Kn. The modulus of rigidity for the steel is 80 GPa. determine

  Determine dilatation and change in volume of the 200m length

determine the dilatation and change in volume of the 200mm length of the rod if A) the rod is made of steel E=200 Gpa v=.30 B)the rod is made of aluminum E=70 Gpa v=.35.

  Provide the velocity distribution for steady flow case

An infinite, long, solid, vertical cylinder of radius R is located in infinite mass of compressible liquid. Provide the velocity distribution for steady flow case

  What interest rate must the investment earn

Determine the length of roadway that is in full superelevation for a four-lane expressway with a 60 mph design speed. The BC of the curve is at station 15+00 and has a minimum allowable radius. The curve delta is 25 degrees and 30’.

  Determine the speed of the collar when it has moved

Springs AB and CD have a stiffness of k = 300 N/m and k' = 200 N/m, respectively, and both springs have an unstretched length of 600 mm. If the 2-kg smooth collar starts from rest when the springs are unstretched

  Find the mass of air in a closed chamber measuring

Find the mass of air in a closed chamber measuring 35 ft by 20 ft by 10 ft, when the pressure is 17 lb/in^2 and the temperature is 75°F, assuming air to be an ideal gas

  Why fine pearlite is harder and stronger than coarse

Briefly describe the simplest heat treatment procedure thatwould be used in converting a 0.76 wt% C steel from onemicrostructure to the other, as follows:

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd