How long would you figure the soil will take to reach

Assignment Help Civil Engineering
Reference no: EM13563744

An oil storage area, abandoned 10 years ago, had spilled oil on the ground and saturated the soil at a concentration of perhaps 400 mg/kg of soil. A fast food chain wants to build a restaurant there, and samples the soil for contaminants, only to discover that the soil still contains oil residues at a concentration of 20 mg/kg. the local engineer concludes that, since the oil must have been destroyed by the soil microorganisms at a rate of 20 mg/kg each year, in one more year the site will be free of all contamination.

a. is this a good assumption? Why or why not?

b. How long would you figure the soil will take to reach the acceptable contamination of 1mg/kg?

Reference no: EM13563744

Questions Cloud

Balance the latitudes and departures by using the compass : A four-sided closed field traverse has the following angles. A = 81 degrees 22%u201930%u201D, B = 72 degrees 32%u201930%u201D, C = 89 degrees 39%u201930%u201D, D =116 degrees 23%u201930%u201D.
Determine the maximum velocity that the skier will achieve : A person with a mass of 200kg wearing snow skis is gliding down a long slope at an angle of 20 degrees. Each ski is 200cm long and 5 cm wide. The pressure of the skis on the snow melts a thin layer of water so that a .1mm layer of water exists under ..
What volume of naocl will be needed : If the plant uses sodium hypochlorite instead, what volume of NaOCl will be needed? Assume that the dry density of NaOCl is 1.2 kg/L and that 1 mg/L of dissolved NaOCl is equivalent to 1 mg/L of dissolved Cl2.
Derive an equation that would allow for direct calculation : A closed system of 0.123kg undergoes a frictionless, quasi-static process along the path PV=C from 100kpa to a final state where the volume is twice the initial volume. During the process 8140 N-m of work is done by the system. What is the final spec..
How long would you figure the soil will take to reach : An oil storage area, abandoned 10 years ago, had spilled oil on the ground and saturated the soil at a concentration of perhaps 400 mg/kg of soil. A fast food chain wants to build a restaurant there, and samples the soil for contaminants.
What is the minimum chain length for the application : A motorcycle sprocket on the rear wheel has a diameter of 24 cm, and trhe driver sprocket has a diameter of 4.0 cm. The driver sprocket shaft and rear axle are 60 cm apart. What is the minimum chain length for the application.
Determine the number of truck loads required to obtain : For construction of an embankment, the soil is transported from a borrowed area using a truck which carries 5.5 m^3 of soil at a time, with the following details: For the Borrowed Pit: bulk unit weight= 16 KN/m^3
Has the issue of having time not wasting become a parvasive : The plant manager has a decision to make. She needs to reduce the concentration of salt in the 8000- gallon tank from 30000 mg/L to 1000 mg/L. she can do it in one of two ways.
Prove that any polygon admits a triangulation : Prove that the smallest angle of any triangulation of a convex polygon whose vertices lie on a circle is the same. This implies that any completion of the Delaunay triangulation of a set of points maximizes the minimum angle.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the soils coefficient of permeability during test

The head difference between manometer levels was 4.9 cm during the test, and the water temperature was 20 degrees celcius. If it took 152 second for 500 ml of water to discharge, determine the soil's coefficient of permeability.

  What will be the surface tension effects if the tube were

A water column in a glass tube is used to measure the pressure in a glass pipe. The tube is 1/4 in. in diameter how much of the water column is due to the surface tention effects? What will be the surface tension effects if the tube were 1/8 in. or 1..

  Calculate the velocity and flow rate of acetone at the exit

A tank containing acetone at 20 oC has a drain pipe connected vertically at the bottom. The pipe is made of galvanized iron, 0.5 in NPS Schedule 40 with length L= 2m. The acetone depth in the tank is H= 5 m.

  What is the trains velocity and what is its displacement

Suppose that the acceleration of the train during the interval time from t=2 to t=4 s is a 2t m/s^2, and at t = 2 s its velocity is v = 180 km/hr. What is the train's velocity at t = 4 s, and what is its displacement (change in position) from t = 2 s..

  Determine the weight of the water and the pressure forces

A 30-ft-high, 1-ft-diameter pipe is welded to the top of a cubic container 13 ft * 3 ft * 3 ft2. The container and pipe are filled with water at 20°C. Determine the weight of the water and the pressure forces on the bottom and sides of the contain..

  Calculate the required flowrate of a dive shop

The owner of a dive shop wants to purchase a constant displacement air compressor capable of simultaneously filling 10 SCUBA tanks. each having a volume of 0.4 ft^3. in 20 minutes.

  Determine the reactive torques ta and tb

A uniformly tapered bronze tube AB of circular cross section and length L=1200mm is fixed at ends A and B, as shown in Figure 5. The outside diameters at end A is Da=60mm and Db=100 mm at B.

  What is the pressure inside the glass

A glass is cleaned in 45 0C hot water and placed onthe table bottom up. The room air at 20 0C thatwas trapped in the glass gets heated up to 40 0C andsome of it leaks out so the net resulting pressure inside is 2 kPaabove ambient pressure of 101 kPa...

  Find out the best way to solve for max shear

Beam is fixed at one end, spans 21' then goes over a roller support then 6' continues to hang over. there is a point load halfway betwen the supports (10.5') and another at the far end.

  What is the maximum tension in the cable due to the 6-k load

Where should a single 500-lb live load be places on the beam so it causes the largest live moment at D? What is this moment? Assume the support at A is fixed, B is pinned, and C is a Roller

  Determine at what time does the minimum volume occur

The inflow to a small reservoir during a storm may be described by the equations Q=1000(1-e^-kt) where Q= flow in cfs k= runoff rate = 1.0 per hour t = time in hours The outflow through the dam gates is held constant at 800 cfs.

  What is the total volume of the vocs emitted each day

Assume that there were 1,100,000 vehicles making a 28.5-mi round trip per day, the average vehicle emission rate for VOCs is 1.3 g/VM , and the molecular weight of the VOC emissions from the mobile sources can still be represented by that of metha..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd