Calculate the pressure and mole fractions in the vapor

Assignment Help Civil Engineering
Reference no: EM13563749

1.Determine the length of an interval of time such that the probability of at least one call in the interval is 0.90

2.Using Raoult's Law or Henry's Law, as appropriate, calculate the pressure and mole fractions in the vapor phase for a system containing a liquid that is 0.3% N2 and 99.7% water (by moles) in equilibrium with its vapor at 80°C.

3.Water is used in a heat exchange to cool 5 kg/s of air from 400 C to 200 C. Calculate (a) the minimum mass flux (kg/s) of the water and (b) the quantity of heat transferred (MJ) to the water each second. The water enters at 20 C and leave at 30 C.

Reference no: EM13563749

Questions Cloud

What steady-state concentration of co will be observed : A person may demonstrate observable effects on the central nervous system when exposed to carbon monoxide at a concentration of 50 ppm, may lose consciousness at a concentration of 250 ppm, and may die at a concentration of 750 ppm. A "typical" urban..
Determine the ph of water in a closed calcium carbonate : Determine the pH of water in a closed Calcium Carbonate Aquifer. Assume that the temperature is again 25oC, and that the aquifer material is pure Calcium Carbonate. Again you must list all species that exist in the system and all equations.
Give one reason why this should be considered by management : A chemical plant produces a process wastewater that contains a relatively high concentration of a small number of nontoxic organic compounds, but very low concentrations of solids or salts.
How long will it take to concentrate the solution : 150,000 mol of aqueous phosphoric acid (H3PO4) solution contains 5.00% H3PO4 by moles. The solution is concentrated by adding pure H3PO4 at a rate of 20.0 L/min.
Calculate the pressure and mole fractions in the vapor : Water is used in a heat exchange to cool 5 kg/s of air from 400 C to 200 C. Calculate (a) the minimum mass flux (kg/s) of the water and (b) the quantity of heat transferred (MJ) to the water each second. The water enters at 20 C and leave at 30 C.
Balance the latitudes and departures by using the compass : A four-sided closed field traverse has the following angles. A = 81 degrees 22%u201930%u201D, B = 72 degrees 32%u201930%u201D, C = 89 degrees 39%u201930%u201D, D =116 degrees 23%u201930%u201D.
Determine the maximum velocity that the skier will achieve : A person with a mass of 200kg wearing snow skis is gliding down a long slope at an angle of 20 degrees. Each ski is 200cm long and 5 cm wide. The pressure of the skis on the snow melts a thin layer of water so that a .1mm layer of water exists under ..
What volume of naocl will be needed : If the plant uses sodium hypochlorite instead, what volume of NaOCl will be needed? Assume that the dry density of NaOCl is 1.2 kg/L and that 1 mg/L of dissolved NaOCl is equivalent to 1 mg/L of dissolved Cl2.
Derive an equation that would allow for direct calculation : A closed system of 0.123kg undergoes a frictionless, quasi-static process along the path PV=C from 100kpa to a final state where the volume is twice the initial volume. During the process 8140 N-m of work is done by the system. What is the final spec..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate manning coefficient n for the given reach

The following data are obtained for a particular reach of the Provo river in Utah: cross sectional area A = 183 ft2, free surface width = 55 ft, average depth = 3.3 ft, Rh = 3.32 ft, V = 6.56 ft/s, length of the reach = 116 ft, and elevation drop ..

  What will be the effect of making an indentation very close

When making hardness measurements, what will be the effect of making an indentation very close to a preexisting indentation. Why.

  Determine heat loss from steam passing through turbine

Steam enters a turbine with neglible velocity at 4 mpa, 600 degrees celcius and a flow rate of 36000 kg/h. Determine the heat loss from the steam passing through the turbine if the turbine has a power output of 20000 kw

  Design hardwood beam to support a uniformly distributed load

Design a hardwood beam to support a uniformly distributed load of 20 kN over a simply supported span of 8 m. consider bending strength only. Assume that the weight of the beam is 2 kN.

  Calculate max tensile force that the cable can withstand

A cable is made of two strands of different materials, A and B, and cross sections as follows: For material A, K = 60, 000 psi, n = 0.6, Ao = 0.6 in2 For material B, K = 30, 000 psi, n = 0.5, Ao = 0.3 in2

  What is the maximum elevation of the reservoir above

A 150 L helium tank contains pure helium at a pressue of 1825 psig. How many 3.5L helium balloons can be filled from the helium  in the tank? (Assume an atmospheric pressue (14.7 psia) and a temp of 298K.

  Regular hexagonal pyramid

A regular hexagonal pyramid has an upper base edge of 16 ft. and a lower base edge of 28 ft. if the volume of the frustum is 18041 ft^3., find the lateral area of the frustum.

  Determine the fraction of h at ph 6 and ph 8

Hydrogen sulfide (H2S) is an odorous gas that can be stripped from solution by gas stripping. The efficiency of the process will strongly depend on the pH of the solution. The equilibrium reaction is: in a pocess similar to ammonia.

  What is the mach number of the flow around the aircraft

A jet aircraft flies at a speed of 600 mph at an altitude of 40,000 ft. The atmosphere is the standard atmosphere. (1) What is the air pressure outside the aircraft (2) What is the Mach number of the flow around the aircraft

  What isthe max increase in temp if the stress in the steel

A square member is composed of a 12 inlong. 1 sq in area steel core with Young's modulus=29*10^6 psi andthermal expansion coefficient of 6.5*10^-6 /deg F

  Question in structure analysis concrete column with

question in structure analysis concrete column with dimension square 300 mm300 mm length 3m and concrete grade c3545.

  If the magnitude of cos t is less then write outan

The tangent function is defined as than (t)=sin(t)/cos(t). This expression can be evaluated to solve for the tangent as long as the magnitude of cos(t) is not too near to 0

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd