Rappahannock above the point where the two streams mix

Assignment Help Civil Engineering
Reference no: EM13542361

The Rappahannock River near Warrenton, VA has a flow rate of 3.00 cms. Tin Pot Run (a pristine stream) discharges into the Rappahannock at a flow rate of 0.05 cms. To study mixing of the stream and river, a conservative tracer is to be added to Tin Pot Run. If the instruments that measure the tracer can detect a concentration of 1.0 mg/L, what minimum concentration must be achieved in Tin Pot Run so that 1.0 mg/L of tracer is to be measured after complete mixing of the stream and Rappahannock has been achieved and that no tracer is in Tin Pot Run or the Rappahannock above the point where the two streams mix. What mass rate (in kg/day) of tracer must be added to Tin Pot Run?

Reference no: EM13542361

Questions Cloud

Plot the mohr circles for both failure stress conditions : Determine (5) the maximum shear stress at failure Tao,max and (6) the angle of the plane on which Tao,max acts; calculate (7) the available shear stress on the plane.
Draw the idealized stress-strain diagram for a material : Write out the final version of Hooke's Law which includes Young's Modulus. Draw the idealized Stress-Strain diagram for a material. On the drawing, please label: the yield stress, the plastic deformation, and the yield strain.
Determine the velocity of the collar at point b for any give : Knowing that the collar is releasted from rest at A, develop an equation to determine the velocity of the collar at point B for any given value of k (k-range is 0.1-2.0 lb/in)
Compute the sorbed concentration in equilibrium with the : If the pH of the water is raised to 8.5, what is the equilibrium concentration of the chromium (III) in moles/L? (d) What weight (in pounds) of precipitate is formed if groundwater containing 19,000 mg/L chromium is treated as described in part (c) a..
Rappahannock above the point where the two streams mix : The Rappahannock River near Warrenton, VA has a flow rate of 3.00 cms. Tin Pot Run (a pristine stream) discharges into the Rappahannock at a flow rate of 0.05 cms
Determine the period of vibration and the maximum : A 30 lb uniform cylinder can roll without sliding on a 15 degree incline. A belt is attached to the rim of the cylinder, and a spring holds the cylinder at rest. If the center of the cylinder is moved 2 in
How much styrene transfers to the ethylene glycol phase : The distribution coefficient of styrene distributed between ethylbenzene and ethylene glycol at 25 degrees C is .19 mass fraction in the ethylene glycol phase per mass
Calculate the head loss in 500 m of pipe : Carbon dioxide flows in a 75 mm diameter PVC pipe at 0.014 kg/s at a pressure of 345 kN/m^2/s abs and a temperature of 10 degrees C. Calculate the head loss in 500 m of pipe.
Determine the actual distance below the surface at which : In the determination of the average velocity of flow in wide rivers, it is common practice to estimate the average velocity in a vertical section by making a single measurement at a distance below

Reviews

Write a Review

Civil Engineering Questions & Answers

  Design a suitable pavement consisting of a granular subbase

if the subgrade has a resilient modulus of 103,500kN/m2, design a suitable pavement consisting of a granular subbase with a layer of coefficient of 0.13, a granular base layer with a layer coefficient of 0.14, and an asphalt concrete surface with ..

  Determine the pressure head required from the pump

A pump is necessary to lift water from the clear well (reservoir) at a water treatment plant to a storage tower 50-ft high and some distance away. A flow rate of 15 cubic per second (cfs) is required (68F).

  Construct an uniform thick deposit of cohesionless soil

A proposed square footing carrying a total load of 900 kips is to be constructed on a uniform thick deposit of cohesionless soil. The soil's unit weight is 135 pcf, and its angle of internal friction is 38 degrees

  What would bethe total flowrate into the reservoir for a run

Suppose the duration of a storm with rain fallingat an intensity (i) of 0.025 inches per hour was such that therational method (Q = C i A) could be used to calculate runoff fromall the land area in the Quabbin watershed.

  Would calcite be over or under-saturated in hot water heater

If log KSO, calcite (CaCO3(s)) = -8.61 at 50 oC, would calcite be over- or under- saturated in a hot water heater at 50 oC if the water was in equilibrium with calcite at 25 oC (log KSO = -8.30) when it entered the house

  Estimate the amount of coal needed to light one 100-w

A 25-W compact fluorescent lightbulb (CFL) produces the light equivalent of a 100-W incandescent bulb. The population of North America is estimated to be about 305 million.

  Darcy law and quantity of groundwater

Using Darcy's Law, calculate the quantity of groundwater (L/day), the seepage velocity (m/s), and the contaminant loading (Kg/day) to the river (assuming no retardation) for the following scenario. Be sure to include both a plane view and cross-se..

  What is the effective stree at the base of the aquifer

THE WATER TABLE OF A SATURATED , UNCONFINED AQUIFER COINCIDES WITH THE LAND SURFACE. THE AQUIFER IS 52 FT THICK AND THE MATERIAL HAS A UNIT WET WEIGHT OF 135 LB/FT^3.

  Calculate the volumetric flow rate inside the hose in units

The hose has an inside diameter of 2 inches. If viscous effects are neglected (inviscid/frictionless flow) and the hose outlet is 10 feet below the surface of the pond, calculate the volumetric flow rate inside the hose in units of gallons per min..

  How to determine the amount of heat loss by the system

A closed rigid tank contains 2kg of saturated water vapor initially at temperature of 433K. Heat transfer occurs from the system and the pressure drops to 150kPa. Determine the amount of heat loss by the system.

  What is the discharge through the pipe for water temperature

A fire hydrant is supplied through a 6 inch cast iron pipe of 16,000 feet length. The total drop in pressure is limited to 35 psi. What is the discharge through the pipe for a water temperature of 80°F ((kinematic viscosity) = 0.93 × 10-5 ft2/sec)

  Determine the moment of the force

A force, 90 N in magnitude, is applied to control rod AB as shown. Knowing that the length of the rod is 225 mm, determine the moment of the force about point B by resolving the force into components along AB and in a direction perpendicular to AB..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd