Fresh water fish do not survive in water

Assignment Help Civil Engineering
Reference no: EM13531080

Glucose is a molecule that is able to diffuse across the plasmamembrane with a diffusion coefficient (D) of 3 x 10-8 cm/sec.

a) If the concentration of glucose in plasma is 5 mM, and theintracellular glucose concentration is negligible (i.e. 0 mM), whatis the rate of glucose diffusion (J) into the cell? Assume that thethickness of the plasma membrane is 10 nm.

Glucose transport can be enhanced (facilitated) by a transportersuch as GLUT3, which has a Km of 1.5mM and transports glucose at amaximum rate (Vmax) of 104 molecules/sec. Using the equation: rate= Vmax ([S]/[S] + Km), how many molecules per second is each GLUT3able to transport when [S] is 5 mM? How much faster is this ratethan simple diffusion?

Fresh water fish do not survive in water with a high concentration of bicarbonate(HCO3-). Briefly explainwhy this is so.

Reference no: EM13531080

Questions Cloud

Determine the maximum shear stresses : A solid steel bar of diameter 30 mm is enclosed by a steel tube of outer diameter 45 mm and inner diameter 36 mm. Both bar and tube are held rigidly at end A and joined securely to a rigid plate at end B. The composite bar, which is 500 mm long, is t..
When analyzing a truss using the method of sections to find : When analyzing a truss using the method of sections to find theforces in specific members. What is a good strategy to helpdecide where to make the cuts to separate the truss into separatesections?
Determine the final speed of the cart : Two men A and B, each having a weight of 160lb stand on a200lb cart. Each runs with a speed of 3ft/s measured relativeto the cart. Determine the final speed of the cart if:
How much flow human lung can deliver cold soda and/or water : One hundre cubic meter of gas at-34.6c celcius and 200kpa in absolute pressure is compressed to a volume of 25 cubic meter and  an absolute pressure of 1000kpa. what is the new temperature, in degrees celsius?
Fresh water fish do not survive in water : If the concentration of glucose in plasma is 5 mM, and theintracellular glucose concentration is negligible (i.e. 0 mM), whatis the rate of glucose diffusion (J) into the cell? Assume that thethickness of the plasma membrane is 10 nm.
What safety factor will be necessary to allow an extraction : A lead-zinc mine is to be developed by a room-and-pillar layout.  The mine is located at a depth of 500ft, the overlying rock has an average specific gravity of 2.56, and the pillar rock wast tested and found to have a
What is the composition of the last solid remaining prior : What is the composition of the last solid remaining prior tocomplete melting?
Determine the concentration of carbon in this alloy : The microstructure of an iron-carbon alloy consistsof proeutectoid ferrite and pearlite; the mass fractions of thesetwo microconstituents are 0.174 and 0.826, respectively. Determinethe concentration of carbon in this alloy.
What must be its composition if this is notpossible : It is desirable to produce a copper-nickel alloythat has a minimum noncold-worked tensile strength of 380 MPa(55,000 psi) and a ductility of at least 45% EL. Is such an alloypossible? If so, what must be its composition? If this is notpossible, then ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determne the diameter of the tube at a uniform rate

A 25 mm diameter steel cylinder falls under its own weight at a uniform rate of 0.1 m/s inside a tube of slightly larger diameter. Castor oil of viscosity 0.25 N.s/m2 fills the spacing between the tube and the cylinder.

  How to calculate the loads into the horizontal members

what does the free body analysis look like and how to calculate the loads into the horizontal and vertical members of a free standing jib hoist with a 15' boom and 5000 pound capacity

  Force exerted by the hydraulic cylinder

The gate is rectangular with a horizontal width of 2m perpendicular to the paper. For a depth h = 3m of water, calculate the required force exerted by the hydraulic cylinder to keep the gate just closed.

  What is probability that it will be found by both inspectors

Items are inspected for flaws by two quality inspectors. If a flaw is present, it will be detected by the first inspector with probability 0.9, and by the second inspector with probability 0.7. Assume the inspectors function independently.

  Replace the two couples with a single equivalent couple

The two shafts in a speed-reducer unit are subjected to couples of magnitude M1 = 18 N · m and M2 = 7.5 N · m, respectively. Replace the two couples with a single equivalent couple, specifying its magnitude and the direction of its axis.

  What do you mean by the term durability

What do you understand by the term durability? Compared to other considerations, how much importance should be given to durability in the design and construction of concrete structures?

  Calculate minimum set-back distance required for highway

Calculate the minimum set-back distance required for a national highway of 4 lane divided carriageway having circular curve of radius of 350 m & design speed 100 km/hr.

  Find the horizontal and vertical forces exerted on the poll

What is the maximum weight that can be suspended on a 16 Kg poll, 3/5 from the end. The maximum tension of the 30 degree guy-wire is 1500 N. Find the horizontal and vertical forces exerted on the poll by the hinge.

  The fixture ac is designed with a screw adjustment to

the fixture ac is designed with a screw adjustment to regulate the height of the 900 n load supported by the roller

  Determine the maximum shear stress at the end

A 600 mm long solid steel shaft is to transmit a torque of 30 N-m, G=90 GPa, diameter 15mm. Determine (a) Maximum shear stress, and (b) Angle of twist (phi) at the end.

  Find the angle of rotation of the free end of the shaft

The solid compound shaft, made of three di¤erent materials, carries the two torques shown. (a) Calculate the maximum shear stress in each material. (b) Find the angle of rotation of the free end of the shaft.

  At what rate is the diameter increasing

a spherical balloon is being inflated so that its volume is increasing at the rate of 5 cu meter/min. at what rate is the diameter increasing when the diameter is 12m?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd