Determine the concentration of carbon in this alloy

Assignment Help Civil Engineering
Reference no: EM13531077

The microstructure of an iron-carbon alloy consistsof proeutectoid ferrite and pearlite; the mass fractions of thesetwo microconstituents are 0.174 and 0.826, respectively. Determine the concentration of carbon in this alloy.

Reference no: EM13531077

Questions Cloud

How much flow human lung can deliver cold soda and/or water : One hundre cubic meter of gas at-34.6c celcius and 200kpa in absolute pressure is compressed to a volume of 25 cubic meter and  an absolute pressure of 1000kpa. what is the new temperature, in degrees celsius?
Fresh water fish do not survive in water : If the concentration of glucose in plasma is 5 mM, and theintracellular glucose concentration is negligible (i.e. 0 mM), whatis the rate of glucose diffusion (J) into the cell? Assume that thethickness of the plasma membrane is 10 nm.
What safety factor will be necessary to allow an extraction : A lead-zinc mine is to be developed by a room-and-pillar layout.  The mine is located at a depth of 500ft, the overlying rock has an average specific gravity of 2.56, and the pillar rock wast tested and found to have a
What is the composition of the last solid remaining prior : What is the composition of the last solid remaining prior tocomplete melting?
Determine the concentration of carbon in this alloy : The microstructure of an iron-carbon alloy consistsof proeutectoid ferrite and pearlite; the mass fractions of thesetwo microconstituents are 0.174 and 0.826, respectively. Determinethe concentration of carbon in this alloy.
What must be its composition if this is notpossible : It is desirable to produce a copper-nickel alloythat has a minimum noncold-worked tensile strength of 380 MPa(55,000 psi) and a ductility of at least 45% EL. Is such an alloypossible? If so, what must be its composition? If this is notpossible, then ..
What is the composition of the ß phase : A hypothetical A-B alloy of composition 40 wt%B-60 wt%A at sometemperature is found to consist of mass fractions of 0.66 and 0.34for the αand β phases, respectively. If the composition of the α phase is 13 wt% B-87 wt% A, what is the composition ofth..
What types of proteins had to have been degraded to isolate : What types of proteins had to have been degraded to isolate theDNA? Why is DNA considered to be an acid?
What is the total lenth ac and its standard deviation : A line AC was observed in 2 sections AB and BC, with lengthsand standard deviations listed below. What is the total lenth AC and its standard deviation?

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the max tensile force that could be applied to steel

a rectangular piece of steel is 10" wide by 60" long by 3" deep, what is the max tensile force that could be applied to the steel, and what is the total elongation of the steel

  Find steady state concentration of pollatant in the lake

fator dumps 5m^3/s of nonconservative waste with concentration 100mg/l into the lake. the pollutant has a reation rate coefficient K of 0,23/day assuming the pollutant is well mixed in the lake, find steady state concentration of pollatant in the ..

  How would structure a portion of an aviation safety program

How would you structure a portion of an Aviation Safety program for a commercial airline or government agency. Briefly describe one or two safety problems and why it is a serious safety problem.

  What thickness of bc will result in same compressive stress

A second load P2 is uniformly distributed around the cap plate at B. The diameters and thicknesses of the upper and lower parts of the post are dAB= 1.25 in, tAB= 0.5 in, dBC= 2.25 in and tBC= .375 in respectively.

  Determine the vertical distance climbed

Neglecting the effect of altitude of local gravitional acceleration, determine the vertical distance climbed. Assume an average air density of 1.18 kg/m^3.

  A paved parking lot section has a uniform slope over a

a paved parking lot section has a uniform slope over a length of 100 m in the flow direction from the point of a

  Develop a simple urban constructed wetland design

Develop a simple urban constructed wetland design.

  A simple rankine cycle uses water as the working fluid the

a simple rankine cycle uses water as the working fluid. the boiler operates at 6000 kpa and the condenser at 50 kpa. at

  Determine the minimum distance from thenbspdiversion that a

a temporary diversion has been constructed on a highway due to major repairs thatnbspare being undertaken on a bridge.

  Explain where the water is coming from for several decades

The Jordan aquifer has been pumped for several decades, yet remains fully saturated. Explain where the water is coming from.

  Determine the changes in kinetic and potential energy

An automobile having a mass of 900 kg initially moves along a level highway at 100 km/hr relative to the highway. It then climbs a hill whose crest is 50m above the level highway and parks at a rest area located there.

  Determine the angle of twist of gears a and c

The 60mm diameter shaft ABC is supported by two journal bearings, while the 80mm diameter shaft EH is fixed at E and supported by a journal bearing at H. If T1= 2 kN*m and T2= 4 kN*m

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd