Find the stress in the steel and the stress in the concrete

Assignment Help Civil Engineering
Reference no: EM13544561

A 14-in. square concrete post is 6ft tall and reinforced by nine 3/4" diameter steel rods. Assume that the materials are high-strength concrete and ASTM-A36 structural steel.

a.) If a compressive load of 250,000lbs is applied to this column, find the stress in the steel and the stress in the concrete.

b.) Find the total axial deformation (strain) of the column.

Reference no: EM13544561

Questions Cloud

Are the elemental semiconductors silicon and germanium : Electromagnetic radiation may be treated from the classical or the quantum-mechanical perspectives. Briefly compare these two viewpoints.
How the extent of marten site formation may be increased : Name the three factors that influence the degree to which martensite is formed throughout the cross section of a steel specimen. For each, tell how the extent of martensite formation may be increased.
What is meant by the concept of parens patriae : What is meant by the concept of parens patriae?
What must be the density of the gas at that section : Gas flows at a steady rate in a 120-mm-diameter pipe that enlarges to a 180-mm-diameter pipe. At a certain section of the 120-mm pipe the density of the gas is 165 kg/m^3 and the velocity is 15 m/s.
Find the stress in the steel and the stress in the concrete : A 14-in. square concrete post is 6ft tall and reinforced by nine 3/4" diameter steel rods. Assume that the materials are high-strength concrete and ASTM-A36 structural steel.
What is the difference in water levels between reservoirs : A wrought iron water line connecting two reservoirs at 20°C has a length of 1500 m, a diameter of 75 cm, two elbows (90º, long-radius, flanged), a fully open gate valve, and a reentrant pipe entrance.
Find the magnitude of the velocity and acceleration for the : Sketch the flow field defined by u=3y, v=2 and derive expressions for the x and y components of acceleration. Find the magnitude of the velocity and acceleration for the point having the coordinates (3,4). Specify units in terms of L and T.
Parallel and perpendicular lines : Write an equation in slope-intercept form of the line that passes through the given point and is perpendicular to the given line - Write an equation in slope-intercept form of the line.
Use a numerical method to estimate the excess pore pressure : At the site of a large scale land reclamation project 2 m of sand overlie a silty clay layer 5 m thick, which overlies highly fractured permeable rock.

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine how long will generator run on a tankful of fuel

A Bonda portable generator is powering a small travelling fridge (120V) in your RV and consumes 125 watts. The efficiency of the generator's gas motor is 23% and the electrical portion (power head) is more efficient at 91%.

  What are the predominant types of bond in each category

what are the three meterials based on the predominant types of bond and what are the predominant types of bond in each category

  What is the smallest number of bulbs to be purchased

A company manufactures a brand of light bulbs with a lifetime in month that is normally distribute with a mean=3 and a variance=1. A consumer buys a number of these bulbs with the intention of replacing them successively as they burn out.

  How many 3-4 inch diameter rivets are required to transmit

How many 3:4-inch diameter rivets are required to transmit 55,000 lb from the two angles to the gusset plate if the allowable shear stress in the rivets is 15,000 psi Assume each rivet carries the same amount of load.

  Design the ramp for the highest horizontal curve

The entrance to Mt. Hood Meadows (elevation 3,075 ft at the point of crossing) is grade separated from Viking highway (elevation 3,050 ft at the point of crossing) and will have to be connected. The two roadways intersect at a right angle.

  Components of ownership

The IIT components of ownership cost based on average annual value are: Tax-3%, Insurance -4%, and Interest-7%. a) What is the average annual value?

  A four-lane freeway two lanes in each direction is on

a four-lane freeway two lanes in each direction is on mountainous terrain with 11ft lanes a 5ft right-side shoulder

  Determine the controlling ct factor at the water temperature

A small city is evaluating disinfection requirements for their drinking water plant. With an average flow of 5 MGD and a peak flow of 9 MGD, determine the controlling CT factor (virus or giardia) when the water temperature is 23 degrees C.

  Determine the force developed along strut ad for equilibrium

Part A Determine the tension developed in cable AB for equilibrium of the 350-lb crate Part B Determine the tension developed in cables AC for equilibrium of the 350-lb crate. Part C Determine the force developed along strut AD for equilibrium of ..

  Calculate the net positive suction head for the system

Pressure loss in the suction pipe work is directly proportional to water veloicty in the pipe work squared, which is inversely proportional to suction pipe work diameter squared.

  Determine the weight of the gate per meter length

The homogeneous gate shown in Fig. P2.88 consists of one quarter of a circular cylinder and is used to maintain a water depth of 4 m. That is, when the water depth exceeds 4 m, the gate opens slightly and lets the water flow under it. Determine the w..

  Determine what is the torque of shaft be

if shaft A have 1200N.m torque with 25cm diameter and the shaft B have diameter of 52cm what is the torque of shaft be

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd