Determine the minimum radius of the new curve if the safe

Assignment Help Civil Engineering
Reference no: EM13564955

A curve of radius 300 ft and e = 10% is located at the section of an existing rural highway, which restricts the safe speed at this section of the highway to 40% of the design speed.This reduction caused a high accident rate at this section.To reduce the crash rate, a new alignment is to be designed with horizontal curve.Determine the minimum radius of the new curve if the safe speed should be increased to the design speed.Use fs = 0.17 for the existing curve.Use e = 10% for the new curve.

Reference no: EM13564955

Questions Cloud

What angle would be needed in order for an equivalent body : The face of a 100m wide rectangular dam is built at an angle of 60 degrees above the horizontal and holds back a body of fresh water that is 30m deep at the face of the dam
What was the distance between the markers : A 100 ft cut steel tape was used to measure between two property markers. The rear surveyor held 93 ft, while the head surveyor cut .67ft. What was the distance between the markers?
Calculate the flow in the river just downstream : An industrial wastewater is discharged into a river about 0.5 km downstream from an outfall (discharge) coming from a desalination plant. Upstream of the desalination plant's outfall the river has a flow of 17.8 m3/sec and a total dissolved solids
What are the final concentrations of no no2 and o3 : A dark atmosphere initially contains no ozone (O3), 100 ppb NO, and 100 ppb NO2. The sun comes comes out and the photostationary state relationship below is achieved in a few minutes. What are the final concentrations of NO, NO2 and O3?
Determine the minimum radius of the new curve if the safe : A curve of radius 300 ft and e = 10% is located at the section of an existing rural highway, which restricts the safe speed at this section of the highway to 40% of the design speed.
Find the theoretical carbonaceous oxygen demand : Suppose a ponds water contains 10.0 mg/L of some algae, which can be represented by the chemical formula C6H15O6N. Using the following reactions:
What are the concentrations of ppm : A sample of air has been collected from above an air stripping tower to evaluate its performance and to determine if toxic air emission standards are being violated
Find the value of the kinetic energy correction coefficient : A symmetric compound channel in overbank flow has a main channel with a bottom width of 30 m, side slopes of 1:1, and a flow depth of 3m.
Determine the dry unit weight of compaction in the field : The results of a field unit weight determination test performed by means of the sand cone method are as follows:

Reviews

Write a Review

Civil Engineering Questions & Answers

  Runoff rate into the inlet grate

If the detention storage on the paved section is increasing at the rate of 60 m3/hr, what is the runoff rate into the inlet grate?

  What is the pressure difference between two ends of pipe

The pipe contains two 6 in steel elbows, two fully open gate valves, a fully open 90o angle valve, and a swing check valve. If the discharge end of the pipe is located 20 ft higher than the entrance, what is the pressure difference between the two..

  Direction of the velecity of the cars after collision

If friction between the cars and the rails is neglected, what were the magnitude and the direction of the velecity of the cars after the collision?

  Compute the power delivered by the pump to the water

Consider friction loss in teh 225-ft-long discharge pipe, but neglect other losses. Then, redesign the system by using a larger pipe size to reduce the energy loss and reduce power required to no more than 5.0 hp.

  Specify the hydraulic retention time for a pfr designed

In each experimental run, the concen tration of free available chlorine was varied and the time required to kill 99% of the organisms was determined. The results showed that a CT value of 200 min mg/L was sufficient to achieve a 2-log removal.

  Find the total axial deformation-strain of the column

A 14-in. square concrete post is 6ft tall and reinforced by nine 3/4" diameter steel rods. Assume that the materials are high-strength concrete and ASTM-A36 structural steel.

  Design square column footing for in square tied interior

Design a square column footing for a 18-in square tied interior column that supports a dead load D= 220 k and a live load L=180 k. The column isreinforced with eight bars, the base of the footing is 4 ft below grade

  What should be the minimal diameter of the above tank

For an elevated storage tank , if the minimum allowable pressure = 300 kPa, Height of pipe system at low-pressure service location = 6 m, and head loss from tank to service location: average daily conditions = 11 m

  How to generate an expression for velocity component

The x-component of a velocity field is ax+b.If the flow is steady, two-dimentional and incompressible; generate an expression for velocity component in the y-direction as a function of x and y.

  Compute the quantity of flow

using darcy's law compute the quantity of flow, seepage velocity and contaminant loading of the river. ground water is flowing through unconfined uniform 3m thick sand aquifer and discharging to river.

  How long does it take before 10 percent of the students

A campus has 5000 students. After the Christmas break one student returns carrying a flu virus. Assume that the rate at which the virus spreads is proportional to the number of infected students P(t),

  Calculate the normal force n exerted by the side of the slot

The flat circular disk rotates about a vertical axis through O with a slowly increasing angular velocity. Prior to rotation, each of the 0.60-kg sliding blocks has the position x = 29 mm with no force in its attached spring.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd