Find the theoretical carbonaceous oxygen demand

Assignment Help Civil Engineering
Reference no: EM13564954

Suppose a ponds water contains 10.0 mg/L of some algae, which can be represented by the chemical formula C6H15O6N. Using the following reactions:

C6H15O6N + 6 O2 -> 6 CO2 + 6 H2O + NH3

NH3 + 2 O2 -> NO3- + H+ + H2O

a. Find the theoretical carbonaceous oxygen demand (CBOD)

b. Find the nitrogenous oxygen demand (nBOD)

c. Find the total theoretical (carbinaceous plus nitrogenous) oxygen demand (ThOD)

Reference no: EM13564954

Questions Cloud

What was the distance between the markers : A 100 ft cut steel tape was used to measure between two property markers. The rear surveyor held 93 ft, while the head surveyor cut .67ft. What was the distance between the markers?
Calculate the flow in the river just downstream : An industrial wastewater is discharged into a river about 0.5 km downstream from an outfall (discharge) coming from a desalination plant. Upstream of the desalination plant's outfall the river has a flow of 17.8 m3/sec and a total dissolved solids
What are the final concentrations of no no2 and o3 : A dark atmosphere initially contains no ozone (O3), 100 ppb NO, and 100 ppb NO2. The sun comes comes out and the photostationary state relationship below is achieved in a few minutes. What are the final concentrations of NO, NO2 and O3?
Determine the minimum radius of the new curve if the safe : A curve of radius 300 ft and e = 10% is located at the section of an existing rural highway, which restricts the safe speed at this section of the highway to 40% of the design speed.
Find the theoretical carbonaceous oxygen demand : Suppose a ponds water contains 10.0 mg/L of some algae, which can be represented by the chemical formula C6H15O6N. Using the following reactions:
What are the concentrations of ppm : A sample of air has been collected from above an air stripping tower to evaluate its performance and to determine if toxic air emission standards are being violated
Find the value of the kinetic energy correction coefficient : A symmetric compound channel in overbank flow has a main channel with a bottom width of 30 m, side slopes of 1:1, and a flow depth of 3m.
Determine the dry unit weight of compaction in the field : The results of a field unit weight determination test performed by means of the sand cone method are as follows:
Calculate the drawdown at the well use r which is the : A gravel-packed well with an effective diameter of 36 in is to be constructed in an aquifer with T = 2.6 x l04 gpd/ft and S = 2.3 x 10-5. The design flow of the well is 1000 gpm.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine concentrations of a and b at outlet of reactor

A fluid flows into a plug flow reactor of volume, V, with volumetric flow rate, Q. Inflow contains species A and B and concentrations A0 and B0. Within reactor, species A undergoes first order reaction producing B... R=k[A].

  Determine the horizontal deflection of joint

The maximum vertical load and horizontal load have been identified and shown in the figure. Under this loading condition, you are asked to determine the horizontal deflection of joint C.

  Estimate the number of water molecules are in the earth

If the flow that you determined in (b) occurred as rainfalluniformly over the earth's surface, what would be the mean annualrainfall (cm/y)?

  Calculate the molar mass of the biomolecule

A 2.50-g sample of a large biomolecule was dissolved in 13.0 g of carbon tetrachloride. The boiling point of this solution was determined to be 77.85°C. Calculate the molar mass of the biomolecule.

  Determine the hydraulic conductivity of the aquifer

Drawdown at a 0.20-m-diameter, fully penetrating well, which has been pumping at the rate of 1000 m^3/day for a long enough time that steady-state conditions have been reached, is determined to be 0.70 m.

  Find the max speed of the bicycle

A bicyclist travels on a level path. The frontal area of tje cyclist and the bicycle is 2 ft^2 and the drag coefficient is .8. The specific weight of aire is .075 lb/ft^3

  Determine the corresponding magnitude of the bending moments

A drilling engineer wishes to support pipes of length L on blocks so that the magnitude of the bending moment in the pipes directly over the supports is equal to the magnitude of the bending moment at the center of the pipes.

  Determine the total force in the connection

An object is submerged in a water tank and tethered by a line to the bottom of the tank. If the object has a density of 45 kg/cubic meter and a volume of 2.5 cubic meters, what is the tension in the line?

  Find probability that all twenty calls go through right away

The phone lines to an airline reservation system are occupied 40% of the time. assume that the events that the lines are occupied on successive calls are independent. assume that 20 calls are placed to the airline.

  Determine the components fa and fb along the oblique

Determine the components Fa and Fb of the 4.2 kN force along the oblique axes a and b. Determine the projections Pa and Pb of F onto the a- and b-axes.

  Determine what will the wires resistance be of the wire

A wire has a resistance of 1.2×10-2 . What will the wire's resistance be if it is stretched to twice its original length without changing the volume of the wire

  Calculate q-w change in u and h for each processes

Cooling at constant pressure followed by heating at constant volume. Calculate Q, W, change in U, and change in H for each of these processes, and sketch the paths of all processes on a single PV diagram.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd