Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Problem 1:
a) Zinc is often used as a coating on steel reinforcement. Explain two ways in which the zinc coating can protect the reinforcement. What would happen if the coating was nicked.
b) Compare the effectiveness of the zinc coating with a typical epoxy coating on reinforcement. How does the epoxy coating protect reinforcement and what happens if the coating is nicked.
Problem 2:
Rank the following materials based on their ability to act as a sacrificial anode on iron. Should any of the materials not be used?
Potassium
Aluminum
Zinc
Lead
Platinum
You are to assume that seawater at 77oF will be used in the tank and the curved portion forms a quarter of a circle. The tank is open to the atmosphere. The overall height, h2, is 20ft deep. The radius of the curve, R, is 5ft. The width of the..
An irrigation micro-tuberises from Point A at the outlet of a supply main, up to the top of a hops trellis(Point B), before dropping down to Point C and extending on to supply an irrigation emitter.
During an experiment, the depth of a water flow in a flume is measured five times by using a ruler with 1/16-in division. The results from these measurements are 4.88 in, 5.06 in, 5.03 in, 5.13 in, 4.94 in. What is the instrumental error and what ..
determine the dimensions of an ideal circular settling tank that can remove 0.01-in diameter particles with a specific gravity of 1.01. Use a detention time of 1.5 hours, flowrate= 4ft^3/sec, the specific weight of water=62.4 lb/ft^3
If the max load is applied to the cylinder (6"x12") or (150x300mm) up to P=500 kips, what would be the compressive strength of concrete for (a) cylinder, (b) 150mm cube, and (c) 200mm cube.
A large steel tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 19,000N. Determine the minimum required wire diameter assuming a factor of safety 5 and that the yield strength of the steel is 900M..
during construction of the surface layer of asphalt pavement, two samples where taken everyday to measure the asphalt content in the mix to ensure that it is within the specification limits. the target value was set at 5.5 percent with a tolerance..
To float a 160 pound man using helium balloons (assume 0.52 cubic feet per inflated balloon). How many balloons would it take? Assume density of air is 1.29 kg/cubic meter and the density of helium is 0.179 kg/cubic meter.
Two 1/2 inch rods are spliced together by glueing a 2 inch section of plastic pipe over the rods ends. If a tensile force P = 350 lb is applied to the spliced nylon rod, what is the average chear stress in the glue joint between pipe and the rods?
A 600 MWe power plant has an efficiency of 36% with 15% of the waste heat being released to the atmosphere as stack heat and the other 85% taken away in the cooling water.
suppose a family of four, living in a home with an area of 100x5oft connects its stormwater drain to the sewer. Assume that 1in of rain falls over 1 day. what percentage increase will there be in the flow from their house over the dry weather flo..
A rectangular landfill in the New England area is 175 m in width, and sloped at the uniform angle of 75 degrees. Its cover system includes a drainage layer constructed of clean, medium sand (Ks = 10^-2 cm/s).
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd