Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An engineer is designing a horizontal, rectangular conduit that will be part of a system that allows fish to bypass a damn. Inside the conduit a flow of water at 40 F will be divided into two streams by a flat, rectangular metal plate. Calculate the viscous drag force on this plate, assuming boundary-layer flow with free-stream velocity of 15 ft/s and plate dimensions of L = 8 ft and W = 4 ft.
Two kilograms of steam at 300kPa and a quality of 75% are heated in a closed container until a pressure of 600kPA is reached. Determine the final temperature of the steam and the heat input.
a 200 lb homogeneous gate of 10 ft width and 5 ft long is hinged at point a and held in place by 12 ft long brace as
A stainless steel tube with an outside diameter of 65 mm and a wall thickness of 5 mm is used as a compression member. If the axial normal stress in the member must be limited to 180 MPa, determine the maximum load P that the member can support.
Water boils at room temperature of 25 degrees celsius when the pressure is 3.17 kPa (abs). Express this as a vaccum gage pressure (in mmHg) if atmospheric pressure is 101 kPa. Provide details of work to get a good rating.
In a three phase balanced system, a delta connected source supplies power to a wye connected load. If the line impedance is 0.2 + j0.4 ohms, the load impedance 3 + j2 ohms, and the source phase voltage Vab = 208 at a 10 degree angle (V rms).
how to design a simply supported rectangular concrete beam having cross section of 20 mm by 40 mm and a length of 3 meters that couldcarry a uniform load of 1000 KN
If rod slides along the horizontal slot with a velocity of 44 ft/s , determine the angular velocity of link BC at the instant
An ideal Brayton refrigeration cycle has a compressor ratio of 3.75. The air enters the compressor at 1bar, 27°C. The temperature at the inlet of the turbine is 77°C. Using Air Standard Method Determine on a per unit mass of air flowing
The water table is 7m below the surface of the sand. The saturated unit weight of the sand is 19kN/m3 and that of the clay 20kN/m3; the unit weight of the sand above the water table is 16kN/m3.
what mass in grams of steam at 100degc must be mixed with 387 g of ice at its melting point in a thermally insulated
The force is applied at the two pins. The pins allow rotation around the z-axis and do not allow rotation around the y-axis. The length of the beam between the pins is 8m. Determine the maximum allowable compressive force that can be applied.
A smart, anti armour weappon is launched of an aircraft flying at 250 knots (422 FT/s) straight and level at an altitude of 300FT above the ground, the weapon is released from the aircraft with an initial downward velocity of 15FT/s.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd