Find the total head loss if the flow velocity

Assignment Help Civil Engineering
Reference no: EM13542322

Water at 72 degress Fahreneit flows through a 110-ft-long, 5-in-diameter wrought-iron pipe that contains the following fittings: one open globe valve, one medium-radius elbow, and one 90 degrees pipe bend (kb=0.13) with a radius of curvature of 45 in. The length of the bend is not included in the 110 ft. There are no entrance or discharge losses. Find the total head loss if the flow velocity is 4.8 fps.

Reference no: EM13542322

Reviews

Write a Review

 

Civil Engineering Questions & Answers

  Determine what is the alkalinity in mg per l as caco3

A water treatment llant and the water treatment plant removes calcium hardness (Ca2+) by precipitating (making) CaCO3(s). If, after establishing equilibrium with CaCO3(s), the dissolved Ca2+ concentration is 10 mg/L and the pH is 10.5.

  Determine what is local acceleration along the centerline

velocity of water in the nozzle is given by V=2t/(1-.5x/L)^2. L = 4ft. When x=.5L and t=3s what is the local acceleration along the centerline. What is the convective acceleration.

  Calculate the longitudinal and transverse stresses

Calculate the overall modulus of the composite, explaining your calculations and the assumptions you have made when it is loaded:

  Determine the time required for a car to travel 1 km

Determine the time required for a car to travel 1 km along a road if the car starts from rest, reaches a max speed at some intermediate point, and then stops at the end of the road. the car can accelerate at 1.5 m/s^2 and decelerates at 2 m/s^2

  Determine the dead load in pounds per linear foot for beams

The beams support one-way slabs, 6 inches thick that span 20 feet center to center. Assume that the beams are 16 inches wide and 24 inches deep. Determine the dead load in pounds per linear foot for the beams, from the concrete structure alone.

  What will be the volume

A sample of neon has a volume of 555 mL when it is at a pressure of 813 mmHg. What will be the volume when the pressure is increased to 1138 mmHg?

  Determine what is the average power output of the cyclist

The force from road drag is 2.5 N and the aerodynamic drag (in Newtons) is equal to 0.2v2 N where the units on 0.2 are N s2/m2 and where v is in m/s. Neglecting drive train losses what is the average power output of the cyclist

  How many loom operators should be employed to minimize cost

A room has 10 cotton spinning looms. Once the looms are set up, they run automatically. The setup time is exponentially distributed, with mean 10 minutes. The machines run for an average of 40 minutes, also exponentially distributed.

  Calculate volume and approximate hydraulic retention time

Primary treatment removes ~25 percent of the BOD. Calculate the volume (m3) and approximate hydraulic retention time (h) of the aeration basin required to run the plant as a "high rate" facility (F/M = 2 kg BOD/kg MLSS-day).

  At what temperature will condensation start to occur

A closed, rigid container with a volume of 1 m3 contains H2O initially at a pressure of 800 kPa and temperature of 500 C. Heat transfer occurs to the surroundings. At what temperature, in deg C, will condensation start to occur

  Calculate the distance upstream from the point of entry

A clean-earth channel, for which n=0.020, is 6m wide and lies on a slope of 0.005236. Water flows at 30m3/s through the channel and enters a reservoir. The water depth in the channel, just before the entry to reservoir, is 3m.

  Provide zero-air voids curve for the soil on the same plot

a) Density plot, locating γd(max) and ω opt on the plot b) Zero-air voids curve for the soil on the same plotc) Curve representing S = 70%

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd