Calculate the required hourly feed rate of oil in gallons/h

Assignment Help Civil Engineering
Reference no: EM13559340

A 50,000 L/day stream of wastewater must be heated from 15 degrees celsius to 40 degrees celsius for a treatment process to work properly. at what rate must we put heat into the stream? assume that wastewater has thermal properties exactly like pure water and the efficiency of heat transfer is 100%. now assume that a steam heater is used to heat the wastewater. calculate the heat that must be contained in steam in order to transfer the required amount of heat into the water stream. assume that the heater has heat losses to the surroundings of 15%. now assume that the steam is produced in a furnace burning a fuel oil that is similar in heat content to crude oil (6.33 * 10^6 kJ/B). assume that the production of steam from the chemical potential energy in the oil has a thermal efficiency of 60%; the remaining heat goes out the stack with the hot gases, or is lost through the hot walls of the pipes or furnace, or other places. calculate the required hourly feed rate of oil, in gallons/hour.

Reference no: EM13559340

Questions Cloud

What distance away from the truck was he when he first : A motorist traveling at 55 mph down a grade of 5% on a highway observes an accident involving an overturned truck ahead of him which completely blocked the road
Find when and the distance that a catches up with b : Two objext A and B are moving along the same line. At the time t=0, B is 75ft ahead of A. The acceleration of A is 1.8ft/s^2 and the acceleration of B is -1.3ft/s^2. The velocity of A is 32ft/s and the velocity of B is 51ft/s.
How do you classify a structure as determinant : If the design speed of a multilane highway is 60 mph, what is the minimum sight distance that should be provided on the road if (a) the road is horizontal and (b) the road has a maximum grade of 5%? Assume the perception/reaction time is 2.5 seconds...
An uncovered swimming pool loses 1 inch of water off : An uncovered swimming pool loses 1 inch of water off its 1,000ft^2 surface each week due to evaporation. the heat of vaporization for water at the pool temperature is 1,050 Btu/lb
Calculate the required hourly feed rate of oil in gallons/h : A 50,000 L/day stream of wastewater must be heated from 15 degrees celsius to 40 degrees celsius for a treatment process to work properly. at what rate must we put heat into the stream? assume that wastewater has thermal properties exactly like pure ..
How far must the plug be compressed downward in order to do : The plug has a diameter of 30 mm and fits within a rigid sleeve having an inner diameter of 32 mm. Both the plug and the sleeve are 50 mm long. Determine the axial pressure p that must be applied to the top of the plug to cause
What minimum tracer concentration must be achieved in stream : River A has a flow rate of 3.0 m^3/sec. Stream B discharges into the river at a flow rate of 0.05 m^3/sec. to study mixing of the stream and river, a conservative tracer is to be added to stream B
What is the volume discharged per unit time : A small circular hole 6.00 mm in diameter is cut in the sideof a large water tank, 14.0 m below the water level in the tank.The top of the tank is open to the air. What is the volume discharged per unit time
Determine the velocity of the airplane : Instruments in airplane A indicate that with respect to the air the plane is headed 30 degrees north of east with an air speed of 480 km/hr. At the same time, radar on ship B indicates that the relative velocity of the plane with respect to the ship ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  How many inches should the channel drop in 350feet of length

design a concrete (n = 0.013) channel that will convey 50,000 GPM. It is to be a trapezoidal in cross section with a bottom width of 7.5 feet. The side slopes are to be 1.33:1 (H:V) and it is desired to have the depth of flow constant at 2.0 feet.

  Write a loop that will estimate the value of the moody f

Use input values of epsilon (B1), pipe radius (B2), and Reynolds number (B3) to estimate "f" and place these in the same cells . Display the final answer in a message box and round to five figures. Use a short cut key of Ctrl+g

  Find density-volume-to-capacity ratio and level of services

A bus strike will eliminate all bus traffic, but it is estimated that for each bus removed from the roadway, seven additional passenger vehicles will be added as travelers seek other means of travel. What are the density, volume-to-capacity ratio,..

  Determine the minor loss coefficient k for a valve

A town is installing a new 10" main to carry drinking water. The only section remaining to be installed is a segment through the middle of town. However, the excavators discover an archaeological site.

  Determine the peak outflow rate

Determine the peak outflow rate when the following inflow hydrograph is routed through this basin. What is the design storage and water surface elevation at the peak outflow rate.

  What should be the surface area of each tank

Do the problem again but for an alum or iron floc with an overflow rate 20 m3/day.m2?

  Determine the self weight moment of inertia

Determine the self weight, moment of inertia, and cross-sectional areas for the following hot rolled standard section:

  Determine volumetric flow rate in head across the turbine

The blade height is 1.0 m, and the inlet radius of the rotor is 7.0 m. The flow exits the turbine in a radial direction. (a) If the angle between the radial direction and the absolute velocity at the inlet is 30o

  Derive the equation of motion

For the beam shown be low, derive the equation of motion in the ∞- and y-directions. Recall that the deformation of a bar along its axis

  The driver initiates a phisical response to the situation

A driver takes 3.2 sec to react to a complex situation while travelling at a speed of 96km/hr.how far does the vehicle travel before the driver initiates a phisical response to the situation?

  Determine pressure drop in length assuming laminar flow

Under these conditions flow is expected to be turbulent, but for a clean air, very smooth enterance (with guided vanes) to the tube and no tube vibration, it may be possible to maintain laminar flow.

  Determine reaction components that ball exert on rod abc

The smooth surface that provides the support at C lies in the y-z plane. Determine the reaction components that the ball and socket exert on rod ABC, the tension in cable BD, and force the smooth wall exerts on end C of rod ABC.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd