P type material - semiconductor material, Electrical Engineering

p type material:

p type material is formed by doping aerial  crystal with impurity atoms having three valance electrons. The diffused impurities with three valence electrons. These doping materials are boron, alliums and indiums. The diffused impurities with three valence electrons   are called acceptor atoms, type material are also electrically neutral.

In a type material the electrons are called the majority carriers and the holes are called the majority carriers.

Posted Date: 2/8/2013 2:22:36 AM | Location : United States







Related Discussions:- P type material - semiconductor material, Assignment Help, Ask Question on P type material - semiconductor material, Get Answer, Expert's Help, P type material - semiconductor material Discussions

Write discussion on P type material - semiconductor material
Your posts are moderated
Related Questions
Q. Using the small-signal equivalent circuit of a BJT with gm = 0.03 S, β = 75, and VA = 65 V, a load resistor RL is connected from the collector to the emitter, as shown in Figure

Q. Explain the fixed bias circuit?           The Fig refers to the common emitter collector characteristics and the ac and dc load lines.The Fig shows the points Q 1 and Q 2

Interrupt latency refers to the amount of time among when an interrupt is triggered and when the interrupt is observe by software.

Hysteresis loss least depends on (A) Frequency.                         (B) Magnetic field intensity. (C) Volume of the material.     (D)Grain orientation of material.

short notes on thermal runaway

Explain effect of frequency of applied electric field. If an external electric field is applied, the distance among charges that is related to chemical bonding keeps constant i

Q. A 150-kVA, 2400/240-V, 60-Hz, single-phase transformer has the following parameters: R 1 = 0.2 , R 2 = 0.002 , X 1 = 0.45 , X 2 = 0.0045 , RC = 10 k, and Xm = 1.55 k,

Explain the Sequential Circuits? The Logic circuits whose outputs, at any instant of time, depends not merely the present input but as well the past output called sequential ci

Determine the magnetic flux: A coil is wound uniformly with 300 turns over a steel ring of relative permeability 900, with a mean circumference of 40mm and cross-sectional are

A Platinum resistance temperature sensor has a resistance of 120 ohm at 0°C and forms one arm of a Wheatstone bridge. At this temperature the bridge is balanced with each of the ot