Writing of a welding procedure specification (wps), Mechanical Engineering

Assignment Help:

Writing of a Welding Procedure specification (WPS)

A typical working procedure specification is written with all the factors of production in mind. Both experience and latest technological awareness help to write an acceptable or successful WPS. The WPS is a list of the following welding variables with the proper values of these entered accordingly.

Welding process
Base metal
Joint design
Filler metal
Position
Preheat / inter pass / post heat
Electrical characteristics
Post weld heat treatment
Gas(es)
Techniques (stringer I weave bead transfer mode, orifice dia, etc.)

Related Discussions:- Writing of a welding procedure specification (wps)

FEM, assignment help needed

assignment help needed

Hazardous waste and material standards, Hazardous Waste and Material Standa...

Hazardous Waste and Material Standards Each hazardous site must be examined and evaluated for its characteristics before workers are allowed entry. This will pre decide an

Newton''s second and third law of motion, Newton's second and third law o...

Newton's second and third law of motion: Newton's second law of motion: If resultant force is acting on particle is not zero, and then acceleration of particle will be prop

Thin uniform wire bent - centre of gravity, Thin uniform wire bent - centre...

Thin uniform wire bent - centre of gravity: Find out the C. G. of the thin uniform wire bent into shape ABC as illustrated in Figure. Solution Assume G be the loc

Sort assignment, introducation to sort assig

introducation to sort assig

Determine mean coil radius - close coiled helical spring, Determine Mean co...

Determine Mean coil radius - close coiled helical spring: A close coiled helical spring contains a stiffness of 1 kN/m in compression to a maximum load of 50 N and a maximum

Nature of shear force and bending moment - load variation, Define the natur...

Define the nature of shear force and bending moment under load variation. Sol.: The nature of SF and BM variation under two-load region is given in the table below

Crankshaft design, i have designed a crankshaft for 3 cylinder engine i wan...

i have designed a crankshaft for 3 cylinder engine i want to know how to balance it

Determine the position and magnitude, The intensity of loading on a simply ...

The intensity of loading on a simply supported beam of 5m span increases uniformly from 8KN/m at one end to 16KN/m at the other end. Determine the position and magnitude of the max

Find out the centroid of the shaded area, Find out the centroid of the shad...

Find out the centroid of the shaded area: Find out the centroid of the shaded area illustrated in Figure (a). Solution The shaded area A may be considered as the

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages