Computer organisation, basic advantage of using interrupt initiated data tr...

basic advantage of using interrupt initiated data transfer over transfer under program control without an interrupt

Define thread cancellation and target thread, Define thread cancellation & ...

Define thread cancellation & target thread. The thread cancellation is the task of terminating a thread before it has completed. A thread that is to be cancelled is often refer

Differentiate pre-emptive and non-preemptive scheduling, Differentiate pre-...

Differentiate pre-emptive and non-preemptive scheduling In a pre-emptive scheduling technique, CPU can be taken away from a process if there is a requirement while in a non-pre

What are the advantages of contiguous allocation, What are the advantages o...

What are the advantages of Contiguous allocation? The advantages are a. Supports direct access b. Supports sequential access c. Number of disk seeks is minimal.

Define lazy swapper, Define lazy swapper. Rather than swapping the enti...

Define lazy swapper. Rather than swapping the entire process into main memory, a lazy swapper is used. A lazy swapper never swaps a page into memory unless that page will be ne

Explain deadlock detection and recovery, Deadlock Detection and Recovery ...

Deadlock Detection and Recovery It's a method of permitting the system to enter a deadlock state, detect it and then recover. Deadlock detection : Is the process of

What is the difference b/w multiprocessing and multitasking, What is the di...

What is the difference between multiprocessing and multitasking? Multi programming means implementing more than one program but here whenever the processor is idle during execu

Define approaches that require knowledge of the system state, Define approa...

Define approaches that require knowledge of the system state?  Answer: Deadlock detection, Deadlock prevention, Deadlock Avoidance.

Inter-process Communication !, My code it didn''t run properly ,i tried to ...

My code it didn''t run properly ,i tried to pass 2 parameter example : ./a.out ls -ll ,but it execute only the ls instead of the ls -ll ! plz help amd thank you ! #include #inclu

Buffering,