What is thermoplastic plastics, Mechanical Engineering

Assignment Help:

Q. What is thermoplastic plastics?

These plastic soften under heat, harden on cooling, and can be resoften under heat. Thus, they retain their fusibility, solubility, and capability of being repeatedly shape. The mechanical properties of these plastics are rather sensitive to temperature and to sunlight and exposure to temperature may cause thermal degradation. Common thermoplastic plastics are: acrylics, poly tetra fluoro ethylene (PTFE), polyvinyl chlorides (PVC), nylons, polyethylene, polypropylene, polystyrene etc,


Related Discussions:- What is thermoplastic plastics

Evaluation of specific volume of steam - thermodynamics , Evaluation of Spe...

Evaluation of Specific Volume of Steam: Specific volume of steam means the volume which is occupied by unit mass of steam. It is expressed in m3 /kg. Specific volume of steam

Boilers, BOILERS: BOILERS : Boilers can be defined as closed pressu...

BOILERS: BOILERS : Boilers can be defined as closed pressure vessels that are used to generate steam at pressure much higher than atmospheric pressure by the transfer of he

Determine maximum stress and modulus of elasticity, Determine maximum stres...

Determine maximum stress and modulus of elasticity:  A composite of glass fibres and epoxy has all of fibres laid along the length and is needed to carry a stress of 12 MPa. T

Strength of materials, A shaft transmits 200kw at 180rev/min between a prim...

A shaft transmits 200kw at 180rev/min between a prime mover and a water pump. calculate the strain energy stored perunit length of the shaft and hence the angle of twist in the sha

Estimate what fraction of heat loss by the fin, A tube assembly constructed...

A tube assembly constructed of Cu with an inside diameter of 1.25 cm, wall thickness of 0.8 mm and circumferential fins around the periphery. The fins have thickness of 3 mm, and a

Determine the change in pressure rise through the compressor, We have a rec...

We have a reciprocating compressor operating at 800 rpm.  Suction pressure and discharge pressure are held constant by other systems that have nothing to do with the compressor.  W

Process planning, we have to design crane we did already with calculation r...

we have to design crane we did already with calculation remaining is process planning

Why we use cold working, Q. Why we use cold working? Cold working takes...

Q. Why we use cold working? Cold working takes place below the recrystallization temperature, and therefore is fundamentally different at the atomic level with effects up to th

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd