The center mark command, Mechanical Engineering

Assignment Help:

The Center Mark Command

We can use  Center Mark command to annotate a circle or an arc with a cross at the center.Illustration above shows a center mark added to a circle quick after a diameter has been drawn.

 

                                                    1930_The Center Mark Command.png


Related Discussions:- The center mark command

Copper-beryllium alloys, Copper-Beryllium Alloys Copper-beryllium allo...

Copper-Beryllium Alloys Copper-beryllium alloys comprise between 0.6 to 2% Be and 0.2 to 2.5% Cobalt. Such alloys can be precipitation hardened and cold worked to improve a te

Determine the percentage increase in power possible, An open belt connects ...

An open belt connects two flat pulleys. The pulley diameters are 300 mm and 450 mm and the corresponding angles of Cap are 160 o and 210 o . The smaller pulley runs at 200 r.p.

Corrosion resistance of tantalum, Q. Corrosion resistance of tantalum? ...

Q. Corrosion resistance of tantalum? Tantalum is readily attacked by strong alkalis, even at room temperature, and therefore, is not suitable for use in processes where the pH

Governor, when the governor is connected to a engine its sensitiveness form...

when the governor is connected to a engine its sensitiveness formula change,why?

Theory of constraints, Theory of Constraints: Goldratt's theory of con...

Theory of Constraints: Goldratt's theory of constraint has attracted the attention of several practioners in the industry. His concept of goal, constraint, and throughput, cri

Importance of stresses in shaft, Importance of stresses in shaft: Wha...

Importance of stresses in shaft: What is  importance of stresses in shaft ? Sol.: In shaft the following significant stresses occur. 1. A maximum shear stress occurs on

Define boot strap air evaporative system, Define the following : (a) Boo...

Define the following : (a) Boot Strap Air Evaporative System (b) Simple VCR System (c) Advantage and disadvantage of VCR system over Air Refrigeration System (d) Reduce

Subcontractor submittals, The Supplier/Subcontractor shall submit, for acce...

The Supplier/Subcontractor shall submit, for acceptance, their Material Traceability and PMI program and procedures, which shall comply with this specification, prior to the sourci

Working of reaction turbine, Working of Reaction turbine: In the impul...

Working of Reaction turbine: In the impulse turbine the steam is expanded, causing pressure and heat drop in nozzle only and the moving blades only direct the steam through an

Horizontal deflection , A  truss  is  shown  in  the  given figure. Compute...

A  truss  is  shown  in  the  given figure. Compute  the horizontal deflection of  joint D formed by  both  the  load  and  fabrication  error  (bar  AE  is  30mm  too  long).  For

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd