What are the different types of distributing frames, Electrical Engineering

Assignment Help:

Q. What are the different types of distributing frames used in exchanges?

Ans:

Different distribution  frames  used  in  exchange  are  displayed in  figure.  Each subscriber in a telephone network is connected generally to the nearest switching office by a dedicated pair of wires. Subscriber loop denotes to this pair of wires.  It would be unwisely to run physically  independent pairs  from  each subscriber premises to exchange. It is far easier to lay cables comprising a number of pairs of wires for different geographical locations and run individual pairs as needed by subscriber premises.

1767_What are the different types of distributing frames.png


Related Discussions:- What are the different types of distributing frames

Illustrates typical thermal noise waveform, Q. Illustrates typical thermal ...

Q. Illustrates typical thermal noise waveform? In general, any physical resistor or lossy device can be modeled by a noise source in series with a noiseless resistor, as shown

What are synchronous decade counters, What are Synchronous Decade Counters?...

What are Synchronous Decade Counters? Alike to an asynchronous decade counter, the synchronous decade counter counts from 0 to 9 and then recycles to 0 again, This is done by

Show schematic arrangement of one- dimensional addressing, Q. Show the sche...

Q. Show the schematic arrangement for: (a) one- dimensional addressing, and (b) two-dimensional addressing, if a 32-kbit ROM is used to provide an 8-bit output word.

Transistor as an amplifier, Transistor as an amplifier: Figure:...

Transistor as an amplifier: Figure:  Amplifier circuit, standard common-emitter configuration. The common-emitter amplifier is planned that is why a small change i

Combinational logic circuit design, Design a circuit to enable a chemical a...

Design a circuit to enable a chemical additive to be introduced into the fluid through another inlet only when the temperature is not too cold or too hot and the fluid is above the

Applications of hall effect, Applications of Hall Effect: (i)  To dete...

Applications of Hall Effect: (i)  To determine whether semiconductor is of n type or p type. (ii) To determine carrier concentration. (iii) Measurement of carrier mobili

Explain the term half duplex transmission, Explain the term half duplex tra...

Explain the term half duplex transmission. A half duplex channel can receive and send, but not at similar time. It's as a one-lane bridge where two-way traffic should give way

Give an account on the operation of the oupled amplifier, Q. Give an accoun...

Q. Give an account on the operation of the R-C coupled amplifie r. When a.c. signal is applied to the base of the first transistor, it appears in the amplified form across its c

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd