Applications of hall effect, Electrical Engineering

Assignment Help:

Applications of Hall Effect:

(i)  To determine whether semiconductor is of n type or p type.

(ii) To determine carrier concentration.

(iii) Measurement of carrier mobility.

(iv) To measure carrier conductivity.

(v)  To detect and measure strength of magnetic field using hall effect magnetometers.

(vi) As hall voltage VH is proportional to product of B and I we have another application known as Hall Effect multiplier. We can obtain the product of two signal where I is made proportional to another signal.


Related Discussions:- Applications of hall effect

Explain magnetostriction, Explain Magnetostriction. Magnetostriction: I...

Explain Magnetostriction. Magnetostriction: If ferromagnetic materials are magnetized a small change of dimensions of the material obtains place. There is a small extension alo

Applications of semiconductors, Applications of Semiconductors Inte...

Applications of Semiconductors Integrated circuits (ICs) SSI, MSI, LSI, and VLSI. Fluorescent materials used in TV screens II-VI (ZnS). Light detectors InSb, CdSe, Pb

EDC, why biasing of bjt transistor is essential?

why biasing of bjt transistor is essential?

Explain frequency response curve of a rc coupled amplifier, Q. Explain the...

Q. Explain the frequency response curve of a  RC coupled amplifier The frequency response curve of a typical RC coupled Amplifier is shown below: In mid frequency range

RESISTACE, What is the value of a resistor marked as 47KK?

What is the value of a resistor marked as 47KK?

Why common collector amplifier is known aa emitter follower, Q. Why a commo...

Q. Why a common collector amplifier is called an emitter follower?         When the input voltage goes through its positive half cycle, the output voltage is also seen to go th

Show the frequency response of rc coupled amplifier, Q. Show the Frequency ...

Q. Show the Frequency response of Rc Coupled Amplifier? 1. At low frequency i.e,less than 50 Hz reactance of Cc is going high hence same part of the signal will pass from one s

Draw the impedance diagram of the system, The one line diagram of a simple ...

The one line diagram of a simple power system is shown below.  The data of the system are given in the table below.  (a) Draw the impedance diagram of the system and mark all im

Switching characteristics - power semiconductor devices, Switching charact...

Switching characteristics When  a positive signal  is applied GTO starts  conducting before  initiation of  conduction anode  current  is zero  and anode to cathode voltage Va

Compute the theoretical and practical frequency ranges, Q. For an RG-290/U ...

Q. For an RG-290/U aluminum rectangular wave - guide, a = 58.42 cm and b = 29.21 cm. Compute the theoretical and practical frequency ranges of operation for the guide.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd