Show silicon n-channel jfet, Electrical Engineering

Assignment Help:

Q. Given that a silicon n-channel JFET has VP = 5 V and IDSS = 12 mA, check whether the device is operating in the ohmic or active region when vGS =-3.2 V and iD = 0.5 mA.


Related Discussions:- Show silicon n-channel jfet

Solutions of question bank needed urgent, Need answers of a question bank o...

Need answers of a question bank of power electronics . It is an assignment. Urgent

Gto - gate turn off, GTO ( Gate Turn Off) GTO stands for gate  turn o...

GTO ( Gate Turn Off) GTO stands for gate  turn off  thyristor . it is four layer  PNPN  device. It can be  triggered into conduction like a conventional thyristor  by a pulse

.#title.Simulation on Half wave rectifier using PSpice, How to plot output ...

How to plot output power Vs load resistor graph using PSpice softwaer for half wave rectifier circuit

Armature reaction, is armature reaction good or bad for dc generator?

is armature reaction good or bad for dc generator?

What are procedures, What are procedures? Procedures are a group of ins...

What are procedures? Procedures are a group of instructions stored as a separate program in memory and it is known from the main program whenever needed. The type of procedure

Determine the expected voltage levels at the output, The subsequent voltage...

The subsequent voltage-source multiplying DAC is to be utilized to convert the digital data stream "11" and "01" to an analog signal.  It has 2-bit inputs and hence is capable of c

Lki load register pair immediate instruction , LKI  Load Register pair  ...

LKI  Load Register pair  Immediate  Instruction This instruction is used to copy or  load  16 bit  data specified  in the  instruction  directly into  the register pair. The i

Drift related to the instruments, If the instruments has no drift it is per...

If the instruments has no drift it is perfectly reproducible. No drift means that with a given input the measured values do not vary with time. Drift may be classified into thre

Where does the real mode on the cpu come from, The original 8086, which onl...

The original 8086, which only had 1 MB of memory. This megabyte is dividing into low memory for IRQ tables, application memory and high memory.

Components in a microprocessor, What are the basic components in a Micropro...

What are the basic components in a Microprocessor? 1) Address lines to refer to the address of a block 2) Data lines for data transmit 3) IC chips 4 processing data

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd