Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Reporting Requirements for Distribution Licensees
Distribution licensees are needs to provide operational reports, commercial reports, financial reports, energy audit reports and interruption reports. We shortly explain the requirements and formats of these reports.
The operational report on Generation Monitoring, Generating Plant Performance and Emission Monitoring has to be given on a monthly basis by the generating stations.
The commercial report has to be given through the distribution companies at the frequency display in the box ahead.
REPORT
FREQUENCY
Load Distribution
Bill Details
Comparison of Actual and Estimated Demand
Metered Data
Un-metered Connection Details
Data on Connections, disconnections and reconnections
Consumer Complaints
Monthly
Billing Cycle
Financial reports of the giving kind have to be presented annually:
Report Title
Fixed Assets (Plant & Machinery) (G,T,D)
Depreciation of Fixed Assets (G,T,D)
Statement of Profit (G,T,D)
Capital Base (T,D)
Loan Details (G,T,D)
Major Investments (G,T,D)
Figure shows the cross-section of an electrostatic problem with translational symmetry: a rectangular coaxial cable. The inner conductor is held at 10 volts and the outer conductor
The variable resistor Z o in the circuit shown in Fig. 1 is adjusted until maximum average power is delivered to Zo. a) Find the value of Z o b) Calculate the maximum av
Apply the rule-of-thumb dc design presented in this section for a silicon npn BJT with β = 70 when the operating Q point is defined by I CQ = 15 mA and I BQ = 0.3 mA, with a dc s
Single Phase Meters Single phase meters are commonly rated for 240 V AC supply; the current ratings are 5/10, 10/20, 2.5/10 or 5/20 A or are for direct connection to the mains
a shunt motor supplied at 230V rms runs at 900rev/min when the armature current is 30A.the resistance of the armature circuit is 0.4 ohms.find the armature input
E l e c t r ons and Holes For T> 0 K, there would be some electrons in the otherwise empty conduction band, and some empty states in the otherwise filled valence ban
What are the different modes in which 8255 Programmable Peripheral Interface (PPI) can operate? Twenty Four I/O lines in 38-bit port groups - A, B and C A and B can be
Describe the following in Electric discharge Machining Process(EDM). a) Dielectric fluids & their characteristic b) Electrodo feed Control c) Flushing System
A bus is a collection of conducting lines that carrier's data, address, & control signals. A bus is two or many wire communication technique. A bus which communicate among two
If the stator windings of an alternator were to be supplied by an AC of frequency f (as opposed to drawing an AC current from them as would be the case for an alternator) then
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd