Roof mounted fan - air-conditioning guidelines, Mechanical Engineering

Assignment Help:

For fan installation detail and indicate correct structural components, drip pan, acoustical and thermal insulation.

Provide special acoustical curbs for critical areas.

Check requirements of explosive proof motors. List fans.

Establish list of interlocks as required.

Coordinate location of fans with structural.

Check requirements of any special finishes (i.e. spark proof, corrosion resistant).

Schedule in specification complete.


Related Discussions:- Roof mounted fan - air-conditioning guidelines

Determine root of equation, Determine root of equation xe x = cosx by Mull...

Determine root of equation xe x = cosx by Muller's method. Solve the following equations by Matrix Inversion method.

Working of gasifier combined cycle power plant, With the help of a neat dia...

With the help of a neat diagram illustrate the working of Gasifier combined cycle power plant. Describe with the help of neat diagram the working of Pressurised water reactor nu

Calculate the closed loop transfer function, Draw schematic diagram of a po...

Draw schematic diagram of a position control system using armature controlled DC Servo motor. Graph the signal flow graph and hence calculate the closed loop transfer function.

Opportunities, what is the positive opportunities for this major

what is the positive opportunities for this major

Kinematic and dynamics, In Figure P4.2 , ?1 = 200 rad/s cw and a1 = 4000 ra...

In Figure P4.2 , ?1 = 200 rad/s cw and a1 = 4000 rad/s2 cw, Find the acceleration of points B, C, and D and the angular acceleration of link 2?

Determine the bolt torque, Q. Determine the Bolt Torque? The value of t...

Q. Determine the Bolt Torque? The value of the bolt torque, which will give the desired bolt stress, can be calculated from Equation. The friction coefficient (K) is for a well

Door strap pull force, A pull up door is stuck in the closed position. A st...

A pull up door is stuck in the closed position. A strap, fastened on the inside bottom and located at the center of the door is pulled outward at an angle of 45 deg above horizonta

What is the procedure of hot working, Q. What is the procedure of hot worki...

Q. What is the procedure of hot working? A process is defined as hot working if it takes place when the workpiece is above the recrystallization temperature. Hot Working Ad

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd