Power distribution system, Electrical Engineering

Assignment Help:

Power Distribution System

The Distribution System contains:

- Sub-transmission system in voltage ranges from 33 kV to 220 kV.

The energy goes from power substations to distribution substations through primary system and then from distribution substations to secondary distribution system for local voltage distribution.

- Primary circuits of feeders, usually operating in the range of 11 kV to 33 kV, supply the load in well defined geographical areas.

- The distribution transformers, commonly installed on poles or near the consumer sites, transform the primary voltage to the secondary voltage, that is usually 240/415 V.

- Secondary circuits at service voltage that carry energy from the distribution transformers along the streets, etc.

  1. The components of Distribution System involved substations, transformers, feeders and metering system, etc.
  2. The O&M objectives and common practices for distribution system focus on improving the reliability and maintenance of plant and equipment, maximizing capacity utilization, increasing operating efficiency, and decreasing operating and maintenance costs.
  3. Grid management, load scheduling and load balancing are significant for the smooth functioning of the power distribution system.

Related Discussions:- Power distribution system

Explain multimeter, Explain multimeter A multimeter, or universal instr...

Explain multimeter A multimeter, or universal instrument, may be used to measure voltage, current and resistance.

Financing the power sector projects, Financing the power sector projects: ...

Financing the power sector projects:   Massive investment is required for the targeted expansion of the sector. It has been estimated at Rs. 9 lakh crores in the further 10 yea

Phase lead controller design and digital implementation, The arm of a hydra...

The arm of a hydraulic robot is controlled as shown in the block diagram below: The arm dynamics are represented by: Dynamic specification for the arm requires:

EEE, ferroelectric materials are charatrised by

ferroelectric materials are charatrised by

Find the flux density in the air gap of the right leg, Q. In the magnetic c...

Q. In the magnetic circuit shown in Figure the center leg has the same cross-sectional area as each of the outer legs. The coil has 400 turns. The permeability of iron may be a

Explain the advantage of synchronous counters, Explain the Advantage of Syn...

Explain the Advantage of Synchronous Counters? The most significant advantage of synchronous counters is that there is no cumulative time delay because all flip-flops are trigg

Compute sending - end voltage current and real power, Q. Athree-phase, 60-H...

Q. Athree-phase, 60-Hz transmission line has a total series impedance of 22.86 62.3°  per phase. It delivers 2.5 MW at 13.8 kV to a load connected to its receiving end. Compute th

Working principle of an electronic voltmeter, Q.   Explain the working prin...

Q.   Explain the working principle of an electronic voltmeter. Sol. Electronic voltmeter Basic Voltmeter: The addition of a series resistor, or multiplier, converts the

#title. electronic project for invention, I need assistance in building a c...

I need assistance in building a circuit for my invention ,I am a electronic tech with limited knowledge but designing and building a proto model is a little out of my expertise ce

Show noise and stability of operational amplifier, Q. Show Noise and Stabil...

Q. Show Noise and Stability of operational amplifier? Noise This refers to the small, rapidly varying, random spurious signals generated by all electronic circuits. Noise

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd