Objective of long-term plans for technical loss reduction, Electrical Engineering

Assignment Help:

Objective of Long-Term Plans for Technical Loss Reduction

The primary objectives of strengthening and improvement of sub-transmission and distribution system in the long-term are to:

1. Reliability and ensure quality of supply to the consumers;

2. Bring it down technical losses to an optimal minimum value; and

3. Phase a system expansion for match a growing power demand in the area under study.

A Sub-Transmission and Distribution system have to be properly planned within the long-term to ensure in which the losses are inside acceptable limits.


Related Discussions:- Objective of long-term plans for technical loss reduction

Unconditional jump - jump instruction , Unconditional Jump JMP ( Uncon...

Unconditional Jump JMP ( Unconditional Jump ) Instruction: This  instruction is used to transfer  the execution to the  specified  memory  address unconditionally ( does not c

#title.Electrical Machine., ) Design a suitable double –layer lap winding f...

) Design a suitable double –layer lap winding for a 6-pole dc armature with 18 slots

What digits are represented by the signal, A signal stands for 0110 with po...

A signal stands for 0110 with positive logic in which low stands for 0 and high stands for 1. If negative logic (in which low stands for 1 and high stands for 0) is used, what digi

Effective mass, Effective Mass The electrons' "wave-particle" motio...

Effective Mass The electrons' "wave-particle" motion in a lattice is not the same as that for a free electron, because of the interaction with the periodic potential of the

What is power gain, Q. What is power gain? Power gain is the ratio of p...

Q. What is power gain? Power gain is the ratio of power delivered to the load to power delivered to the amplifier is the power gain. A p =P o /P i     =V o I o /V i I s

Show silicon n-channel jfet, Q. Given that a silicon n-channel JFET has V P...

Q. Given that a silicon n-channel JFET has V P = 5 V and I DSS = 12 mA, check whether the device is operating in the ohmic or active region when v GS =-3.2 V and i D = 0.5 mA.

Switching characteristics - power semiconductor devices, Switching charact...

Switching characteristics When  a positive signal  is applied GTO starts  conducting before  initiation of  conduction anode  current  is zero  and anode to cathode voltage Va

Control systems design, You are to choose a particular application, model a...

You are to choose a particular application, model and simulate it using MATLAB and or SIMULINK. 1. Modelling 2. Testing and verification of the model 3. Demonstration o

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd