Lhld load hl pair direct instruction, Electrical Engineering

Assignment Help:

LHLD  Load  HL Pair Direct  Instruction

This  instruction is used to copy the  content  of memory  location specified  by opened  in register L  and copy the content of next  memory  location in register H.  Suppose  memory  location specified  by operand is 3010H then the next  memory  location  would by 3011H. The  LHLD instruction  would therefore  copy the  content  of memory   location 30110H in  register  L  and  copy the  content  of memory  location 3011H in register  H. The  instruction format is

LHLD 16  bit  address

( L - [ 16 bit address]

H -  [16 -bit address +1


Related Discussions:- Lhld load hl pair direct instruction

Sketch the phasor diagram showing all the voltages, Q. A balanced wye-conne...

Q. A balanced wye-connected load with a per-phase impedance of 4 + j3  is supplied by a 173-V, 60-Hz three-phase source. (a) Find the line current, the power factor, the total

Sources of power dissipation in cmos logic, Describe the three main sources...

Describe the three main sources of power dissipation in CMOS logic. Hence calculate the power dissipated in a CMOS ASIC of 40,000 gates operating at a frequency of 133MHz with a s

Name 5 different addressing modes, The five addressing modes are given belo...

The five addressing modes are given below: Immediate, Register, Direct, Implied addressing modes           Register indirect,

Determine the study of robotics, Determine the study of Robotics Robots...

Determine the study of Robotics Robots can comprise embedded processors or be linked to a computer system. They are pre-programmed to do a specific task or taught' to remember

Transparent latch d flip flop, Transparent latch D flip  Flop A typica...

Transparent latch D flip  Flop A typical  example  of this  type of D flop  is 7475 shown  in figure when CLK  connected is enable signal is high and the flip  flop  is enabled

Lc filter, LC Filter To the load resistance R L the ripple factor i...

LC Filter To the load resistance R L the ripple factor is directly proportional in the inductor filter and inversely proportional to R L in the capacitor filter. Hence i

Compute the theoretical and practical frequency, Q. An RG-139/U rectangular...

Q. An RG-139/U rectangular waveguide is given to have dimensions a = 0.8636 mm and b = 0.4318 mm. Compute the theoretical and practical frequency ranges of operation for the guide.

Voltage divider with ac bypasses capacitor, Voltage divider with AC bypasse...

Voltage divider with AC bypasses capacitor: Figure: Voltage divider with capacitor The standard voltage divider circuit that is discussed above faces a drawback - A

Digital control system, block diagram of digital control system and explain...

block diagram of digital control system and explain each block

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd