Find the new operating point in transistor, Electrical Engineering

Assignment Help:

Q. A transistor in a fixed bias amplifier circuit was replaced by another transistor of beta equaling 150 instead of 60.if IB of transistor is equal to 100 microampere and collector saturation current was 10 mill ampere. Find the new operating point. Even though the transistor is changed, the base current remains the same that is 100 microampere.

The collector current becomes

IC=B*IB  = 150*100E-6=15 mA

The collector saturation current was 10mA.This would be same even if the transistor is replaced. But the calculated current IC is seen to be greater than IC(Sat).Hence the transistor is now in saturation. So the operating point can be specified as

IC = IC(SAT) =  10mA

VCE = 0V


Related Discussions:- Find the new operating point in transistor

MATLAB, Future scope on MATLAB in India

Future scope on MATLAB in India

Power system I, a single phase is supplied with sinusoid voltage v(t)=200co...

a single phase is supplied with sinusoid voltage v(t)=200cos(377t).the resulting instantaneous power is p(t)=800+1000cos(754t-36.7). find

Determine whether the diode in circuit, Determine whether the diode (consid...

Determine whether the diode (considered to be ideal) in the circuit of Figure (a) is conducting.

Calculate the current flow using thevenin''s theorem, Calculate the curren...

Calculate the current flow in 30Ω resistor for the circuit in figure using Thevenin's Theorem.

Find the ratio of the forward to the reverse current, Assume that an abrupt...

Assume that an abrupt Si p-n junction with area 10-4 cm2 has NA=10 17 /cm 3 and ND=10 17 /cm 3 is working at room temperature. It is given that μ n = 700 cm 2 /v-s, μ P =250 cm

Numerical analysis curve fitting, Ask question #Minimum 100 wThe voltage v...

Ask question #Minimum 100 wThe voltage v across a capacitor at time t seconds is given by the following table. Use the principle of least squares to fit a curve of the form v = ae

Clipper and clamper circuit, Clipper Circuits: Clipper circuit have ab...

Clipper Circuits: Clipper circuit have ability to Clipper of portions of the input signals without distorting the remaining part of the alternating wave form. Clamper net

What are the different types of coupling in amplifiers, Q. What are the dif...

Q. What are the different types of coupling in amplifiers? The coupling between stages of amplifications may also be used to classify amplifiers. There are four main groups: di

Comparison of analog-modulation systems, Comparison of Analog-Modulation Sy...

Comparison of Analog-Modulation Systems The comparison of analog modulation systems (conventional AM, DSB SC, SSB SC, VSB, FM, and PM) can be based on three practical criteria:

D flip flop - introduction to microprocessors, D Flip Flop As we have ...

D Flip Flop As we have seen  in the SR flip flop  when the inputs  S= R  are applied the forbidden or indeterminate state occurs.  This state can destabilize the SR file flop.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd