Find the induced armature voltage at rated load, Electrical Engineering

Assignment Help:

Q. A50-kW, 230-Vcompound generator has the following data: armature-circuit resistance 0.05 , series-field circuit resistance 0.05 , and shunt- field circuit resistance 125 . Assuming the total brush-contact drop to be 2 V, find the induced armature voltage at rated load and rated terminal voltage for: (a) short-shunt, and (b) long-shunt compound connection.


Related Discussions:- Find the induced armature voltage at rated load

Integrated circuit with resistive feedback, principle of resistive feedback...

principle of resistive feedback circuit change when the square wave and triangular pulse frequencies, the amplitude of the triangle wave

Rectification, diagram for full wave bridge circuit single phase,full wave ...

diagram for full wave bridge circuit single phase,full wave centre tap circuit and haif wave rectification circuit

Give the significance of sim and rim instruction, Give the significance of ...

Give the significance of SIM and RIM instruction available in 8085. Instruction SIM: Set Interrupt Mask. This is a 1 byte instruction and can be used three dissimilar functio

Low investments in transmission and distribution system, Low Investments in...

Low Investments in Transmission and Distribution System The investment on T&D system in our country has commonly been lower than that on generation. It is hugely believed in

Forth generation, Forth Generation VLSI  technology  of IC made it poss...

Forth Generation VLSI  technology  of IC made it possible  to design the  complete  circuit  of ALU  Arithmetic  logic unit and cu ( Control Unit ) within  single  chip  which

Magnet, Magnetic materials

Magnetic materials

What are encoder and the decoder, There are zillions of things in electroni...

There are zillions of things in electronics known as encoders. You can look up LCDs and NAND gates as well and this is actual basics.

Vhdl, how to construct universal shift register using D-flipflop and mux??

how to construct universal shift register using D-flipflop and mux??

Mov - move instruction, MOV ( Move ) Instruction It copies  the content...

MOV ( Move ) Instruction It copies  the contents of the sources register into destination register. The general format is . This  instruction  is used  to copy 8 bit  from s

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd