Features and usage of peripheral component interconnect bus, Electrical Engineering

Assignment Help:

Discuss features and usage of Peripheral Component Interconnect bus.

Peripheral Component Interconnect bus has plug as well as play characteristics and the capability to function with a 64-bit data bus. The PCI interface has series of registers, located in a small memory device upon the PCI interface which contains information about the board.

Related Discussions:- Features and usage of peripheral component interconnect bus

Find the meter reading assuming that the averaging is done, Q A residence i...

Q A residence is supplied with a voltage v(t) = 110√2cos120πt Vand a current i(t) = 10√2cos120πt A. If an electricmeter is used tomeasure the average power, find the meter reading,

Explain about darlington amplifier, Q Explain about 'Darlington Amplifier'?...

Q Explain about 'Darlington Amplifier'? DARLINGTON AMPLIFIER : A CC stage followed by another CC stage has an input resistance of about (b + 1) 2 times the emitter resistance

Microcontroller interfacing, The winch uses a 415 Volt 50 Hz AC motor, so b...

The winch uses a 415 Volt 50 Hz AC motor, so both the up/down and run/stop controls actually operate +24V relays, whose contacts switch the 415Vac to the winch. The relays also pro

Single- and three-phase systems, Ac power has significant practical advanta...

Ac power has significant practical advantages over dc power in generation, transmission, and distribution. One major drawback of the single-phase circuit is the oscillatory nature

Rar rotate accumulator right through carry instruction , RAR Rotate Accum...

RAR Rotate Accumulator Right Through Carry Instruction This instruction rotates the contents of the accumulator towards right by one bit. The D 7 bit moves to D 6 posi

Analog, why h parameter used in low frequency transistor amplitfier

why h parameter used in low frequency transistor amplitfier

Partial fraction expansion for z transformation, how should I calculate in...

how should I calculate inverse z transform of 1/0.729z^-1+0.729z+1.5314

Write short notes on the stability factor of biasing circuit, Q. Write shor...

Q. Write short notes on the Stability Factor of Biasing circuits. The degree of success achieved in stabilizing Ic in the face of variations in Ico is expressed in terms of sta

Find the current, 1. A 1 μm long and 100 μm 2 cross-sectional area silicon...

1. A 1 μm long and 100 μm 2 cross-sectional area silicon bar is doped with 10 16 /cm 3 phosphorous. Use the graph below to: a. Find the current at 300°K with 10 V applie

Ac, power factor improvement

power factor improvement

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages