Line Protection., Electrical Engineering

Assignment Help:
The Lennox to Bowmanville 500 kV circuit, spanning a distance of about 180 km,
has series (inductive) impedance j 0.0224 pu and shunt (capacitive) admittance j 2.34 pu,
quoted on base values of 500 kV and 100 MVA. Determine the following:
(a) Line charging current (in Amps) drawn by the line when supplied from one terminal
with the supply bus operating at 500 kV (note that system/bus operating voltage is
always quoted on a phase-to-phase basis, unless specified otherwise)
(b) Steady-state phase to ground voltage (in pu) at the opposite line terminal (due to
Ferranti rise) when the line is placed on potential as above. (HINT: For this
calculation, the line is modeled by its nominal-pi representation, with half of the line’s
shunt capacitance connected to ground on each side of the total (series) line
inductance, as depicted below.

Related Discussions:- Line Protection.

logical and with accumulator instruction , ANA  Logical AND with Accumula...

ANA  Logical AND with Accumulator Instruction This  instruction is used to logically AND the accumulator  of any register or memory location  with the  accumulator and the r

What is current gain in rc coupled amplifier, Q. What is current gain  in R...

Q. What is current gain  in RC coupled amplifier? Current gain is the ratio of the output current to the input current. we represent it as A i . A i =I o /I s it can

What is the function of gate signal in 8254 timer, What is the function of ...

What is the function of gate signal in 8254 timer? The  8254 has three independent 16-bit counters, which can be programmed to. Work in any one of possible six modes. Every cou

Develop a block diagram of an asynchronous decade counter, Q. Counting to m...

Q. Counting to moduli other than 2 n is a frequent requirement, the most common being to count through the binary-coded decimal (BCD) 8421 sequence. All that is required is a four

Bad effects of armature reactions, Q.  What is meant by armature reaction....

Q.  What is meant by armature reaction. Explain briefly the bad effects of armature reactions.   Sol. By armature reaction is meant the effect of magnetic field set up

Explain the nor gates - microprocessor, Explain the NOR GATES - Microproces...

Explain the NOR GATES - Microprocessor The NOR GATE is an OR gate with the output inverted. Consequently the outputs of a NOR gate would have the opposite states as the outputs o

What are the features used mode 2 in 8255, What are the features used mode ...

What are the features used mode 2 in 8255? The single 8-bit port in-group A is available. 1. The 8-bit port is bi-directional and additionally a 5-bit control port is availa

Calculate the cross-sectional area, Calculate the cross-sectional area, in...

Calculate the cross-sectional area, in mm 2 , of a piece of aluminium wire 100 m long and having a resistance of 2Ω. Take the resistivity of aluminium as 0.03 x 10-6 Ωm.

#title.MIPS assembly language code., Given the INPUT: • An array of 64-bit ...

Given the INPUT: • An array of 64-bit unsigned integer elements stored in the memory starting at a known location SOURCE. • The size of the array (i.e., number of elements) stored

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd