Explain the 16-bit registers dptr and sp of 8051, Electrical Engineering

Assignment Help:

Explain the 16-bit registers DPTR and SP of 8051.

DPTR:

DPTR stands for data pointer. DPTR having of a high byte (DPH) and a low byte (DPL). Its function is to hold a 16-bit address. It might be manipulated as a 16-bit data register or as two independent 8-bit registers. It serves as a base register in indirect jumps, lookup table instructions and external data transfer.

SP:

SP stands for stack pointer. SP is an 8- bit wide register. It is enhanced before data is stored during PUSH and CALL instructions. The stack array can reside anywhere in on-chip RAM. The stack pointer is initialised to 07H after a reset. This causes the stack to start at location 08H.

 


Related Discussions:- Explain the 16-bit registers dptr and sp of 8051

Alternator, How can I design alternator?

How can I design alternator?

Explain the memory map of transient program area in a pc, Draw the memory m...

Draw the memory map of TPA in a personal computer and explain different areas. The transient program area holds the DOS operating system and other programs which control the co

Phase equilibria, distinguish between brittle and ductile fracture

distinguish between brittle and ductile fracture

Torque required to turn a self excited generator, Work must be done against...

Work must be done against the electromagnetic torque in order to generate the voltage (and current) supplied to the electrical load connected to the generator. Therefore energy con

Explain the synchronous compensators, Explain the Synchronous Compensators ...

Explain the Synchronous Compensators These are synchronous motors running without mechanical loads (or with load if required). Similar to the synchronous generators, they can a

Its use in civil engineering, applications of electronics device (bjt,mosfe...

applications of electronics device (bjt,mosfets) in civil engineering

Find out form factor and peak factor, Find out Form factor and Peak factor:...

Find out Form factor and Peak factor: For the output of full wave rectifier, find out (a) RMS value, (b) Average value, (c) Form factor, and (d) Peak factor. S

Add instruction , ADD Instruction Op code  format  of ADD instruction...

ADD Instruction Op code  format  of ADD instruction is Replace  the three bit code  of the register R from   to obtain the op code of the  required ADD instruction . op co

How many bits are required, This problem concerns entropy There are hund...

This problem concerns entropy There are hundred students in a midterm exam. There are 5 grades and the number of students having each grade is shown below. At a min

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd