signals, Electrical Engineering

Assignment Help:


Using the audiorecorder() function in MATLAB, make a recording of your voice. Use a sample rate of 8kHz, 16 bits per sample, and aim to record around 2 seconds worth.

Quantize the audio samples down from the original 16 bits by removing the least-significant bit (LSB) from the waveform, to make a 15 bit recording. Repeat for 14, 13, 12 bits, down to 1 bit.

Explain how you would do this in MATLAB, and implement your approach.

Listen to the recordings, and make a table with the number of bits and the corresponding quality assessment. This can simply be a subjective assessment; use terms such as ''no perceptual difference'', ''minor noise present'', ''quite noisy'', ''poor quality'' etc.

Calculate the signal-to-noise ratio in each case, and add that to your table. Explain how you calculated the SNR.

Related Discussions:- signals

Use of computers in power systems, Q. Use of Computers in Power Systems? ...

Q. Use of Computers in Power Systems? The control and stability of any electric power system is indeed extremely important, in particular when a system is expected to maintain

What is photovoltaics?, Photovoltaics  is a high-technology approach  to ch...

Photovoltaics  is a high-technology approach  to changing sunlight  directly  into  electrical  energy.  The  electricity  is direct  current  and  can  be  used  that  way,  chnag

Compute the current loss in the lines, Q. Consider a 240-V supply feeding a...

Q. Consider a 240-V supply feeding a resistive load of 10 kW through wires having a total resistance of R = 0.02 . For the same load, let a 120-V supply be used with a total wire

Find the slip and the rotor frequency at full load, Q. A three-phase, 50-Hz...

Q. A three-phase, 50-Hz induction motor has a full load speed of 700 r/min and a no-load speed of 740 r/min. (a) How many poles does the machine have? (b) Find the slip and t

Requirement specification for the monitor and alarm system, Prepare a User ...

Prepare a User Requirement Specification for the monitor and alarm system. User Requirements Specification should be written in a clear and unambiguous manner to state: • The

What is time switches, Q. What is Time Switches? Principle of a time sw...

Q. What is Time Switches? Principle of a time switch is displayed in Figure. It connects an incoming n channel PCM highway to an outgoing n channel PCM highway. As any incoming

What is difference between voltage and potential, Voltage is referred as Po...

Voltage is referred as Potential difference among two points. Potential means its force. I think so.voltage defination is 100% correct.

Show maximum common-mode input voltage, Q. Show Maximum Common-Mode Input V...

Q. Show Maximum Common-Mode Input Voltage of amplifier? This is the maximum voltage that the two inputs can be raised above ground potential before the op amp becomes nonlinear

Commercial losses in electrical systems, Commercial Losses in Electrical Sy...

Commercial Losses in Electrical Systems Commercial losses are caused by pilferage, theft, defective meters, and errors in meter reading and in estimating un-metered supply of

Drive operating envelopes and induction machines, Solve using data from the...

Solve using data from the DC machine data sheet, using the "hot" resistance value for all calculations. Note that the value of K on the sheet is for rated (100%) field flux. Assum

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd