power electronics, Electrical Engineering

Assignment Help:
A step-down transformer has primary turns Np = 100; secondary turns Ns = 10; primary winding resistanceRp = 100 ?; secondary winding resistance Rs = 2 ?. Assume that there is no leakage inductance and that the magnetizing inductance is very, very large. (This essentially means that the transformer is ideal, with the exception of winding resistances). The transformer is driven on the primary side with 120V, 60 Hz.
(a) What is the unloaded output voltage at the transformer secondary?
(b) What is the output voltage across the load when the transformer is loaded with RL = 10 Ohms?
(c) When loaded, what is the transformer primary (Ip) and secondary (Is) current?
(d) Simulate the loaded condition of part (b) with PSIM and verify your results.

Related Discussions:- power electronics

Explain the working of electronic multimeter, Q.  Give suitable block diag...

Q.  Give suitable block diagram to explain the working of electronic multimeter. Sol. An electronic multimeter is a laboratory instrument which is capable of measurement of

Explain interrupts of 8085, Explain Interrupts of 8085. a) Maskable  in...

Explain Interrupts of 8085. a) Maskable  interrupt b)  Vectored interrupt c)  Non maskable interrupt d) Hardware interrupt e)  Software interrupt

Compute the transfer function from the input, In this project we will consi...

In this project we will consider the control of a synchronous generator supplying electricity to the grid. We will focus on the problem of frequency stability. The frequency at whi

Illustrates typical thermal noise waveform, Q. Illustrates typical thermal ...

Q. Illustrates typical thermal noise waveform? In general, any physical resistor or lossy device can be modeled by a noise source in series with a noiseless resistor, as shown

Embedded system, 10. List the three ways in which an RTOS handles ISRs in a...

10. List the three ways in which an RTOS handles ISRs in a multitasking environment

Sketch one full period of the am wave, Q. Let a(t) = [1 + m A x(t)] and x(t...

Q. Let a(t) = [1 + m A x(t)] and x(t) = cos 2πf m t, f m c , and x c (t) = A(t) cos 2πfct . (a) With m A =1, sketch one full period of the AM wave and draw the envelope by co

Binary coded decimal to decimal conversions, Binary Coded Decimal to Decima...

Binary Coded Decimal to Decimal Conversions • Step1. Break up the Binary Coded Decimal number into 4 bit binary number, starting from the least significant binary bit. • Step2

Digital controller for a steam-turbine driven generator, Q. Digital control...

Q. Digital controller for a steam-turbine driven generator? Figure illustrates the basic elements of a minicomputer system in terms of a block diagram for speed and voltage con

Explain jmp instruction and call instruction., Explain the difference betwe...

Explain the difference between a JMP instruction and CALL instruction. A JMP instruction permanently alters the program counter. A CALL instruction leaves information on the st

Pop instruction, POP Instruction This instruction  copies the contents ...

POP Instruction This instruction  copies the contents  of the top  two locations  of the  stack into the  specified  register pair. The  contents  of stack pointer register are

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd