Explain sand and moulding sands, Mechanical Engineering

Assignment Help:

Q. Explain Sand and moulding sands?

Sand according to the amount of clayey matter they contain, the moulding sands are classified as:

• Silica sand: Up to 20% clay.
• Lean or weak sand: 2 to 10% clay
• Moderately strong sand: 10 to 20% clay
• Strong sand: Up to 30% clay
• Extra strong sand: Up to 50% clay.

There are three types of sand used for making moulds: natural, synthetic and chemically coated.


Related Discussions:- Explain sand and moulding sands

Calculate the greatest stress - plate, Calculate the greatest stress - plat...

Calculate the greatest stress - plate: A rectangular plate 10 mm thick within a hole of 50 mm diameter drilled on this is as shown in Figure 10. This is subjected to axial pul

Clutch cable model-Clutch Complaint, Clutch cable model: Ensure the cables...

Clutch cable model: Ensure the cables fitted are of the respective model and not interchanged with other model. Also ensure that the cable is genuine.

Objectives of motorcycle servicing , Objectives After studyingmotercyc...

Objectives After studyingmotercycle servicing, you should be able to appreciate the importance of regular servicing and maintenance of a motorcycle and also to recommen

Thermal efficiency and compression ratio, Thermal efficiency and compressio...

Thermal efficiency and compression ratio: Calculate thermal efficiency and compression ratio for automobile working on otto cycle. If energy generated per cycle is thrice whi

Vibration damping and size-factors in clutch design , Vibration Damping : ...

Vibration Damping : Suitable mechanism should be incorporated within the clutch to eliminate (to reduce it drastically) noise produced in the transmission. Size : The size of

Use of high temperature materials in furnaces, Q. Use of high temperature m...

Q. Use of high temperature materials in Furnaces? Often, furnace tubing and refractory protected membrane walls are fabricated from plain carbon steel with a minimum of 0.25% c

Determine the minimum required wire diameter, A large tower is to be suppor...

A large tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 13,300 N (3000 lb f ). Determine the minimum required wire diameter,

Illustrate the term directional solidification, Describe some special kind ...

Describe some special kind of patterns and indicate the production circumstances in which each would be need. Illustrate the term Directional solidification as applied in castin

Tom, ‘coefficient of insensitiveness’ of governors

‘coefficient of insensitiveness’ of governors

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd