Elements of cad, Mechanical Engineering

Assignment Help:

Human Factor : The human factor is the key factor in the success of CAD system. This concerns the training of the designer or the engineer without whom the CAD system becomes redundant. The trained designer may be actively involved in CAD process due to the followings factors.

A. computer aided analysis,

B. computer aided visualization,

C. computer aided synthesis

System Factor : The other factor which matters is the system factor. The system of CAD consists of two components namely the hardware and the software. The hardware forms the physical components. A typical list of hardware for CAD system is given as follows:

a. The CAD workstation,

b. Display Devices,

c. Interaction Devices,

d. Output Devices


Related Discussions:- Elements of cad

I-Section, An unsymmetrical I-Section as shown in figure below. If maximum ...

An unsymmetrical I-Section as shown in figure below. If maximum bending stress is not extend more than 40MPa in the section than find out the moment which it can bear

Density and specific volume - thermodynamics, DENSIT Y (ρ ): Density ...

DENSIT Y (ρ ): Density is defined as mass per unit volume; Density = mass/ volume; = m/v, kg/m 3 P for Hg = 13.6 × 103  kg/m 3 for water = 1000 kg/m 3 Specifi

Heat exchangers for plant design, Q. Heat exchangers for plant design? ...

Q. Heat exchangers for plant design? All exchangers shall be arranged to be readily dismantled for cleaning and maintenance. Cooling and heating streams generally flow against

Lean mixture -mixture requirement , Lean Mixture: It generally ranges...

Lean Mixture: It generally ranges from approximately 15 : 1 to 17 : 1. By the use of this fuel, engine runs for higher economy.

What is transmission system and what do you mean by a gear?, (a) What is tr...

(a) What is transmission system? Represent the main components of transmission system with the help of diagram. (b) What do you mean by terms torque, power and RPM? (c) What

Locomotive boiler4s, explain working and construction of locomotive boilers...

explain working and construction of locomotive boilers

What is carbon steel, Q. What is Carbon steel? Carbon steel has long be...

Q. What is Carbon steel? Carbon steel has long been used for handling concentrated sulphuric acid under ambient temperature and low velocity conditions. In service, a soft sul

Calculate the time required to complete the job, Five jobs are performed fi...

Five jobs are performed first-on Machine-I and then on Machine-II. Time in hours taken by each job on each machine is given below :

Determine the angular-velocity of uniform bar, Determine the angular-veloci...

Determine the angular-velocity of uniform bar: A uniform bar of length l and mass M is hinged at its end B and is released from its horizontal position BA. Determine its angul

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd