Draw the bending moment and shear force diagram, Mechanical Engineering

Assignment Help:

Draw the bending moment and shear force diagram for the following cases :

a) A cantilever beam of length (L) carrying a Point load (W)at its free end.

b) A simply supported beam of length (L) carrying a uniformly distributed load of over the whole span.

Related Discussions:- Draw the bending moment and shear force diagram

Show the support locations for truckable skid, Q. Show the support location...

Q. Show the support locations for truckable skid? Unless instructed otherwise by Engineer, support locations for truckable skid shall be determined by skid Vendor. Support loca

Used engine oil and hot engine parts , Used Engine Oil: Used engine oil ma...

Used Engine Oil: Used engine oil may cause skin disease if repeatedly in contact with the skin for prolonged time. It is advisable to thoroughly wash the hands with soap and water

Kinematics, the jet transport b is flying north with a velocity vb=600km/h ...

the jet transport b is flying north with a velocity vb=600km/h when a smaller aircraft a passes un-derneath the transport

Takt time for sand blasting, Takt Time for sand blasting: ...

Takt Time for sand blasting: Tatk time is crucial in manufacturing process. It determines the speed of production to produce a product. Time is money toward prod

Explain the difference between si and ci engines, Difference between SI and...

Difference between SI and CI engines SI engine stands for spark ignition engine while CI engine stands for compression ignition engine. SI engine works on the principle of w

Explain the 3-2-1 principle of location, Explain the 3-2-1 Principle of Loc...

Explain the 3-2-1 Principle of Location A work piece can be positively located by means of 6 pins so positioned that collectively they restrict the work piece in nine of it

Determine reactions at supports of loaded beam, Determine reactions at supp...

Determine reactions at supports of loaded beam: Determine reactions at supports A and B of loaded beam as shown in the figure given below. Sol.: First co

What is called materials which can store electrical energy, Materials which...

Materials which can store electrical energy are called (A) magnetic materials. (B) semi conductors. (C) dielectric materials. (D) super conductors. Ans: Mater

Ratio of belt tension, Prove that the ratio of belt tension is given by the...

Prove that the ratio of belt tension is given by the T 1 / T 2 = e μθ Let T1 = Tension in belt on the tight side T2 = Tension in belt on the slack side θ = Angle

Advantages of using cam, 1. Greater Design Freedom : Any changes that are ...

1. Greater Design Freedom : Any changes that are required in design can be incorporated at any design stage without worrying about any delays since there would hardly be any i

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages