What is hydraulic press, Mechanical Engineering

Assignment Help:

(i) Hydraulic press:

1399_22.png

 

This can be used to lift a heavy load placed on the platform of larger piston or to press the things placed among the piston and the heavy platform.              

(ii) Hydraulic Brake: Hydraulic brake system is used in auto-mobiles to retard the motion. The rule of hydraulic brake is same as that of the hydraulic lift.

517_22.png

 

 

 


Related Discussions:- What is hydraulic press

High resistance or low current in primary coil circuit, If High Resistance ...

If High Resistance or Low Current in Primary Coil Circuit Causes of Problem Remedy   Disconnected or loose wires

Analysis and design-power calculations-vehicle cost, The EV is to be used f...

The EV is to be used for city transportation, it should carry a maximum total load of 325 kg (passengers and cargo). The battery back used will be 365 kg, 44 kilowatt hours lithium

Engine, Single Cylinder Vertical Engine has a bore of 30cm and a stroke of ...

Single Cylinder Vertical Engine has a bore of 30cm and a stroke of 40cm. The connecting rod is 100cm long. The mass of the reciprocating parts is 140Kg on the expansion stroke with

Overview of project phases, Q. Overview of Project Phases? Conceptual ...

Q. Overview of Project Phases? Conceptual Engineering Phase The purpose of this phase of work is to develop the Client's proposal to a level of detail adequate to determin

#totto cycleitle.., for an otto cycle, compression ratio=8.5:1,air inlet=15...

for an otto cycle, compression ratio=8.5:1,air inlet=15degree celsius and pressure=101.3kpa, maximum cycle temperature= 1800degree celsius, what is temperature after compression,te

Supports for rigid bodies - space structures, Supports for Rigid Bodies (Sp...

Supports for Rigid Bodies (Space Structures): The primary step in solving equilibrium problems is to draw free-body diagram. Isolate the body through its surrounding. Replace

Influence lines for the force, Solve the following two questions of the tru...

Solve the following two questions of the truss. Note that A and G are pin supports.  1)  Sketch the influence lines for the force in bar DG (the load is moving on the top chord

Explain rake angle - angles of a drill, Explain Rake angle - Angles of a dr...

Explain Rake angle - Angles of a drill It is also known as helix angle .It is the angle formed between a plane containing the drill axis and the leading edge of the land. It c

Calculate the outer diameter of hollow shaft, A solid shaft of diameter d i...

A solid shaft of diameter d is taken in power transmission. Because of modification of existing transmission system, it is needed to replace the solid shaft by a hollow shaft of th

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd