Dissimilarity between open stirrups and closed stirrups, Civil Engineering

Assignment Help:

Question
What is dissimilarity in request between open stirrups and closed stirrups in Concrete beams?

Answer
Open stirrups are supplied principally to oppose shear forces in concrete beams and they are functional in locations in which effect of torsion is insignificant. U-shaped stirrups are located in tension side of concrete beams in which shear cracks will occur. Still, when concrete beams are designed to oppose a significant amount of torsion, closed stirrups must be used in its place.


Related Discussions:- Dissimilarity between open stirrups and closed stirrups

Can you determine the quantity of apron stone, Q. Can you determine the Qua...

Q. Can you determine the Quantity of apron stone? Quantity should be sufficient to cover the scoured face down to maximum depth of scour obtained using scour factor c of 2.5 at

Define analytical methods approved under the clean water act, Define Analyt...

Define Analytical Methods Approved Under the Clean Water Act? Analytical Methods Approved Under the Clean Water Act CWA Section 304(h) needs EPA to publish test procedures (ana

What are the stresses on the plane of failure, A granular soil is subjected...

A granular soil is subjected to a minor principal stress of 200 kN/m 2 . If the angle of internal friction is 30°, verify the inclination of the plane of failure with respect to th

Tension members, Tension Members: You have learnt about the Standard s...

Tension Members: You have learnt about the Standard specification for structural steel and various types of structural steel rolled sections. Different types of loads, stresse

State the short term effects of concrete, State the Short Term Effects of c...

State the Short Term Effects of concrete These are various types of effects produced, nearly instantaneously, due to the application of external loads on structures. An example

Purpose of setting minimum amount of longitudinal steel area, Q. Purpose o...

Q. Purpose of setting minimum amount of longitudinal steel areas for columns? In some design codes it specifies that area of longitudinal steel reinforcement must be not less

Frame, what is imperfect frames ?

what is imperfect frames ?

Plane table sureying, discuss the resection method of plane table sureying ...

discuss the resection method of plane table sureying in detail

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd