Determine the work done, Mechanical Engineering

Assignment Help:

Determine the work done per minute by a punch tool making 20 working strokes min when a 30 mm diameter hole is punched in 5 mm thick plate with ultimate shear strength of 450 MPa in each stroke.


Related Discussions:- Determine the work done

What do you mean by flares and vents, Q. What do you mean by Flares and Ven...

Q. What do you mean by Flares and Vents? A vent is a potential gas fuel source and a potential liquid fuel source due to carry-over from the vent. This is also true for a flare

Maintenance of bridges - culverts and shoulders, Maintenance of Bridges and...

Maintenance of Bridges and Culverts: Careful inspection of bridges and culverts at periodic intervals can detect cracks, foundation settlement, scour, malfunction of bearings

Open coiled helical spring, Open coiled helical spring: In an open coi...

Open coiled helical spring: In an open coiled helical spring along with α = 38 o , if the inclination of the coil is ignored, determine the percentage by which the axial exten

Cam profile, sketch and discuss the uses and application of the following t...

sketch and discuss the uses and application of the following types of cam follower;knife edge,roller and flat ended.

The percentage elongation of the metal-stress , Question 1 A metal rod h...

Question 1 A metal rod has a diameter of 8.74 mm and supports a load of 24.6 kN. Calculate the value of true stress on the rod. The diameter was measured with the load already a

Velocity ratio for open belt drive, V elocit y Ratio for Open Belt Drive:...

V elocit y Ratio for Open Belt Drive: Figure Consider a simple belt drive (that is one driver and one follower) as shown in the figure given below Let D 1

Molding methods according to the method of making a mold, Q. Molding method...

Q. Molding methods according to the method of making a mold? Following are the molding methods according to the method of mold making: • Open mold method: the method is su

Stresses., temparature stresses in composite bars

temparature stresses in composite bars

Explain the principle of screw conveyer, Explain the Principle of screw con...

Explain the Principle of screw conveyer When materials are feed into the fixed chutes, due to action of gravity of materials and the friction force between material and chute t

Thermodynamics.., what is critical pressure, triple point, degree of super ...

what is critical pressure, triple point, degree of super heat...

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd