Insulation for personnel protection, Mechanical Engineering

Assignment Help:

Q. Insulation for personnel protection?

Insulation for personnel protection shall be provided as follows on all piping and equipment adjacent to work platforms or other operating areas where the maximum operating bare metal temperature exceeds 60ºC:

a) horizontal piping where the bottom of pipe elevation is less than 2.5 m above grade or a working platform;

b) those portions of vertical piping less than 2.5 m above grade or a working platform;

c) piping adjacent to and within 600 mm of a working platform; and

d) where specified by OWNER.

Insulation of piping for personnel protection shall be limited to pipe and pipe fittings, excluding flanges and valves.

Where required, insulation for personnel protection shall be installed from 150 mm above grade or working platform to a height of 2.5 m above grade or working platform.

Insulation for personnel protection is not required where screens are to be installed for this purpose.

Where alternate personnel protection measures are considered economical, details shall be submitted to OWNER for approval.


Related Discussions:- Insulation for personnel protection

Calculate the critical crack length, Calculate the critical crack length: ...

Calculate the critical crack length: A wide plate of mild steel is subjected to uniform tensile load causing a stress of 100 MPa. Calculate the critical crack length in the ce

Determine the rate of heat removal - mechanics, Determine the rate of heat ...

Determine the rate of heat removal: Carbon dioxide passing through heat exchanger at rate of 100kg/hr is cooled down from  800 0 C to 50 0 C . Write down the steady flo

Thyristor fundamentals of electricity , Thyristor: The thyristor is just l...

Thyristor: The thyristor is just like an ordinary diode. Thyristor

Horizontal deflection, truss is shown in the following figure. Compute the ...

truss is shown in the following figure. Compute the horizontal deflection of joint D produced by both the load and fabrication error (bar AE is 40mm too long). For all bars, area A

Causes and remedies of motorcycle problems , CAUSES AND REMEDIES OF MOTORCY...

CAUSES AND REMEDIES OF MOTORCYCLE PROBLEMS  If Engine Overheats Causes of Problem Remedy   Incorrect spark plug make/model

Tunnels and laying of track, Tunnels: Tunnels become unavoidable for ...

Tunnels: Tunnels become unavoidable for negotiating hills, where detours are costly. The tunnels in rock are not lined, but those in loose strata require a lining of cement c

Quality control specialist, At site locations, the WorleyParsons QC Special...

At site locations, the WorleyParsons QC Specialist (QCS) is responsible to verify that the requirements for PMI as specified in the purchase order/subcontract documents are impleme

Determine the efficiency of bell coleman cycle, (a) Derive a mathematical e...

(a) Derive a mathematical expression to determine the efficiency of Bell Coleman Cycle. (b) A dense air refrigeration cycle acts between pressures of 4 bar and 16 bar. The air t

Show conceptual layout of plant, Q. Show Conceptual Layout of plant ? D...

Q. Show Conceptual Layout of plant ? During the Evaluate phase of a project, the early concept design considers broad information of the expected installation, and its basic cr

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd