Determine the actual attenuation , Electrical Engineering

Assignment Help:

(a) Design a passive high pass filter that has a maximally flat response with a 50  Ω resistive load. Assume that the cut-off frequency is 40 kHz and that at a frequency of 25 kHz, the response is down at -10 dB.

(i) Determine what type and order of filter is best suited for this application.

(ii) State the filter transfer function.

(iii) Sketch the expected (approximate) frequency response of the filter

(b) Draw the filter circuit diagram showing the component values and determine the actual attenuation obtained at f=25 kHz and at f=40 kHz.

(c) By simulating the circuit or otherwise, obtain the actual frequency response of the filter.

 


Related Discussions:- Determine the actual attenuation

transmisson medium, Can I find out the salution of electrods Transmissio...

Can I find out the salution of electrods Transmission medium light sound uncoupling magnet for high dc cycle.

Electronic voltage regulators, Electronic voltage regulators: Electron...

Electronic voltage regulators: Electronic voltage regulators operate through comparing the actual output voltage to a few internal fixed reference voltages. Any type of differ

Trivector meter, Trivector Meter A trivector meter is designed to reco...

Trivector Meter A trivector meter is designed to record active, reactive and apparent energy along with MD indicators on all. The trivector meter is a compact unit.  It exchan

amplitude modulated waveform, The method by which electrical signals conve...

The method by which electrical signals convey information has been described. Systems components have been selected and interfaced to enable a chosen system to perform a desired o

Earth leakage-earthing, Earth Leakage : Earth leakage takes place when, th...

Earth Leakage : Earth leakage takes place when, through some fault in an appliance or its connections. Electric current escapes to earth i.e. the body of the appliance become 'liv

Find the per-phase impedance of the load, Q. The two-wattmeter method for m...

Q. The two-wattmeter method for measuring three-phase power is applied on a balanced wye-connected load, and the readings are given by W C = 836W and W A = 224 W If the system

Power distribution, Determine the current through each parallel branch of t...

Determine the current through each parallel branch of the system

Voltage falls across a resistor simple circuit, To design a VI that can be ...

To design a VI that can be used to show how the voltage falls across a resistor in a simple CR circuit when excited by a step function. The title of the VI will be Capacitor Res

Use mesh analysis and nodal analysis to determine current, Q. Use (a) mesh ...

Q. Use (a) mesh analysis and (b) nodal analysis to determine the current through the 4-resistor of the circuit of Figure.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd