Define phase, Mechanical Engineering

Assignment Help:

Define Phase.

A phase is a quantity of matter that is homogeneous during in chemical composition and physical structure. Determine if the matter is all gas, all liquid or all solid, it has physical uniformity. Likewise, if chemical composition does not change from one part of the system to another, it has chemical uniformity. Instances of one phase system are a single gas, a single liquid, a mixture of gases or a solution of liquid contained in a vessel. A system containing liquid and gas is known as a two-phase system. Water at triple point exists like water, ice and steam at the same time forms a three-phase system.

 


Related Discussions:- Define phase

Determine the instantaneous hydrostatic force, A 6 cm diameter rubber ball ...

A 6 cm diameter rubber ball weighing 5 g is used to plug a 4 cm hole in the base of a tank. The tank is in use and is gradually emptying. At approximately what depth will the ball

Pin shift return spring-gear complaints, pin shift return spring : Check p...

pin shift return spring : Check pin shift return spring for proper torque.

Ignition system-electrical system , Ignition System: The ignition system i...

Ignition System: The ignition system is a source and a means of initial spark required to start burning of fuel. A very high voltage supplied at the spark plug tip causes this spa

Insulatlon application information, The Contractor shall perform all work w...

The Contractor shall perform all work with the highest quality workmanship throughout to provide a neat, uniform appearance with no sharp edges exposed. Insulation shall not be

MRP 1, Advantages and disadvantages

Advantages and disadvantages

Determine maximum tension in the belt, The following data is provided for b...

The following data is provided for belt transmission dynamometer as shown in figure, NA = 400 r.p.m., DA = 750 mm, DB = DC = DD = 250 mm, L = 800mm, Power = 8KW. Determine :- Th

What are the various types of wear found in cutting tool, What are the cond...

What are the condition that could allow a continuous chip to be formed in a metal cutting ? How is metal removed in metal cutting? Illustrate the Process with neat sketch. What

What is the density of plastic, Plastics are the common term for a wide ran...

Plastics are the common term for a wide range of synthetic or semi synthetic polymerization products. There are many dissimilar plastics; all have their own density!

How cad system communicate with control system, How CAD system communicate ...

How CAD system communicate with control system The concept of a universal data exchange system is depicted in figure. In this figure, it is shown how various CAD systems commun

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd