Combustion , Mechanical Engineering

Assignment Help:
How do i calculate the flame radius and flame speed if unstretched flame speed=2.8m/sec and markstein length=5 mm. ?

Related Discussions:- Combustion

Determine the break power of the engine, If a Laboratory experiment, the fo...

If a Laboratory experiment, the following data were recorded with rope Break dynamometer : Diameter of fly-wheel = 1.2 m Diameter of the rope = 12.5 mm Speed = 200 r.p.m.

Calculate the damping ratio, A second order system defined by Where r(t)...

A second order system defined by Where r(t) is a unit step function. Calculate the damping ratio, damped natural frequency, undamped natural frequency, peak overshoot occurs, ri

Determine the ratio of the inlet pipe diameter, Air flows steadily at the r...

Air flows steadily at the rate of 0.5 kg/s through an air compressor, entering at 7m/s velocity, 100 kPa pressure, and 0.95 m 3 /kg volume, and leaving at 5 m/s, 700 kPa, and 0.19

Plate clutch for warpage-clutch jerking, Plate clutch for warpage : Place ...

Plate clutch for warpage : Place plate clutch on surface plate and check for warpage. Ensure that 0.20 mm feeler gauge does not slide freely.

Evaluation of force exerted by jet on the plate, (a) What are the assumptio...

(a) What are the assumptions made during evaluation of force exerted by jet on the plate ? (b) A jet of water which has diameter of 8 cm. issues with a velocity of 40 m/sec. and

Iges application protocol, IGES application protocol: In the year 1977...

IGES application protocol: In the year 1977, the three authors of The Initial Graphics Exchange Specification were identified collectively for their contributions to the growt

Fault detection and isolation for lateral flight of an uav, Introduction   ...

Introduction   Fault tolerance is very important for aircraft flight control.  The majority of the faults occur in the sensors and actuators onboard the aircraft.  Once a fault

Fluid Mechanics, I would like a help for my fluid mechanics assignment

I would like a help for my fluid mechanics assignment

Laser sources-carbon dioxide (co2) lasers, Carbon Dioxide (CO 2 ) Lasers ...

Carbon Dioxide (CO 2 ) Lasers   The CO 2 laser is a gas discharge device and it operates by electric excitation of an active medium that is a mixture of helium, nitrogen an

Statements of second law of thermodynamics, (a) Show that two statements of...

(a) Show that two statements of Second Law of thermodynamics are equivalent to each other. (b) A house that was heated by electric resistance heater consumed 1200 KWh of electri

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd